TreeOperation

循环冗余校验16位的，c语言编程环境，能够正常运行，程序详细注释(16 bit cyclic redundancy check, C language programming environment, normal operation, procedures detailed notes)

实用CAN与上位机通讯例程，适用于基于CAN总线的自动系统参考。(Practical CAN and PC communication routines for automated reference system based on CAN bus.)

① 设计进程控制块PCB表结构，分别适用于优先数调度算法和循环轮转调度算法。 ②建立进程就绪队列。对两种不同算法编制入队子程序。 ③编制两种进程调度算法：1）优先数调度；2）循环轮转调度 (① design process control block PCB table structure, respectively, for priority scheduling algorithm and round-robin scheduling algorithm. ② establish a process ready queue. Two different algorithms for the preparation of subroutine into the team. ③ preparing two kinds of process scheduling algorithm: 1) priority scheduling 2) round-robin scheduling)

实现声音导引小车运动，智能小车程序C51代码(Achieve sound AGV Sport, smart car program code C51)

基于VISA的，采用lan口通信的，安捷伦示波器读取数据的程序。(VISA-based, using the lan port communications, Agilent oscilloscope program to read the data.)

单片机音频通信9170和9200，接收发送源程序(9170 and 9200 microcontroller audio communication, the receiver sends source)

BF51实验板CAN通信器件SJA1000驱动代码(BF51 experimental board SJA1000 CAN communication device driver code)

说明：  本系统以单片机AT89C51为主体,由芯片插座、独立按键、74HC573驱动8位数码管显示、5V直流电源控制模块等组成。根据数字集成芯片的引脚特性以及集成芯片的真值表编写检测程序。该系统能完成14脚以内常用TTL74系列数字集成芯片的功能测试。(This system is the main body of the single-chip microcomputer AT89C51, the chip socket, independent buttons, 74HC573 Driver 8 digital control, 5V DC power control module and so on. According to the characteristics of the digital chip and the chip s true value, the program is written in the chip.. The system can complete the functional test of the TTL74 series digital IC chip in 14 feet.)

用keilC 开发的基于nRF24LE1的wifi收发程序，已经用于实际数据传输系统(keil C wifi nRF24LE1)

定时器：设定时间格式（00：:00）后，到时间弹出提示(timer：set time(00:00),then run up)