PIC24Calculator

该程序利用89c51单片机和lcd液晶显示实现简易的数字示波器，可以显示输入的方波、正弦等信号。压缩包包括硬件连接和软件设计。(The program using 89 c51 and LCD liquid crystal display a simple digital oscilloscope, can display the input square wave and sine signal.Package including the hardware connection and software design.)

使用VB与PIC采集,采用软件中断方式，使用研华1710集成卡。(Using VB with PIC acquisition, the software interrupt, use the the Advantech 1710 integrated card.)

基于MSP430G2553的频率计数计的程序编写，已经过测试，程序无误可以完整运行。(Based on the frequency count MSP430G2553 meter programming, has been tested, the program can complete run correctly.)

Pocket 2003 Imager_SDK_14.12.20086 for software engineereing.

CodeWarrior仿真与调试要点，CodeWarrior仿真与调试要点，CodeWarrior仿真与调试要点(CodeWarrior simulation and debugging points, CodeWarrior simulation and debugging points, CodeWarrior point emulation and debugging)

A Beginner’s Guide to Modeling with NEC vol 3

optimize ADX range usedn in amiborker optimization

这是一个用51单片机系统仿真ucosii工作的protues电路 本系统包括扩展64k RAM的单片机系统和杨屹移植到51单片机的ucosii 系统 使用方法： 1.安装Protues7.4版，然后用protues打开protues 8051 simulation 文件夹 中的extern ram.DSN 文件 2.打开extern ram.DSN 后，双击单片机在弹出的窗口中的Program File 选项 中选择yy.hex文件。 (yy.hex其实就是yy文件夹中keil文档编译出来的hex文 件，yy文件夹是杨屹的ucos51 系统，用keil 2 可以打开) 3.在Clock Frequency选项中输入22.184M(杨屹的ucos51 用的是22.184M hz的单片机频率) 4.双击VTERM串口调试显示屏，在Baud Rate 选项中选择19200的波特率 5.保存，点击运行就可以看到经典的hello world 了。 (1. Protues7.4 version installed, and then open the protues folder protues 8051 simulation The extern ram.DSN file 2. Open extern ram.DSN, double-click the pop-up window of SCM in the Program File option, select yy.hex file. (yy.hex actually yy folder keil out of the document compiled hex files, yy folder is Yang Yi s ucos51 system, using keil 2 Can open) 3. In the Clock Frequency option to enter 22.184M (Yang Yi of the ucos51 using a microcontroller 22.184M hz frequency) 4. Double-click VTERM serial debug display, in the Baud Rate select 19200 baud rate options 5. Save, click Run you can see the classic hello world)

使用1602显示的38khz红外解码程序(1602 shows 38khz using infrared decoder)

无线传能控制程序，主级，能够实现无线充电，但是需要硬件的配合。(Wireless energy transfer control program, the main stage, enabling wireless charging, but requires the hardware support.)