登录
首页 » Visual C++ » numeric-trapezium

numeric-trapezium

于 2020-11-19 发布 文件大小:13KB
0 257
下载积分: 1 下载次数: 3

代码说明:

  一个数字梯形,选择k条路线,每条路线从第一层的某个数开始,每次进入下一层到达左下或者右下的数字,直到最后一层为止。每条路线不能经过相同的路径,但是可以经过相同的数字节点。 输出一个整数,表示能得到的最大的k条路径经过的数字之和(A digital ladder, the K route, each route the first layer of a number, each time to enter the next layer to reach the left or right next to the number, until the final layer. Each route can not pass through the same path, but can pass through the same number of nodes. Output an integer representing the sum of the number of the largest K paths that can be obtained)

文件列表:

数字梯形问题描述.doc,22528,2015-10-07

下载说明:请别用迅雷下载,失败请重下,重下不扣分!

发表评论

0 个回复

  • clock
    说明:  看电子电路时序图如何看,这是个好方面,可以看看(Electronic circuit timing diagram to see how the look, this is a good side, you can see)
    2011-04-03 09:20:03下载
    积分:1
  • usb_host_printer_pcl_5
    说明:  惠普打印机 PCL5 语言 命令函数程序代码参考(hp pcl5 printing command reference)
    2011-03-17 21:31:23下载
    积分:1
  • USB-mouse
    一个鼠标基于C8051f340为核心的USB鼠标程序,在开发板上已调可用。用Keil打开。(A mouse-based core C8051f340 USB mouse program has been transferred is available on the development board. Opened with Keil.)
    2014-05-02 17:02:37下载
    积分:1
  • xunjixiaoche
    51单片机控制智能小车循迹小车c源程序5路循迹(51 MCU control smart car)
    2013-04-10 14:16:05下载
    积分:1
  • 18b20
    使用51单片机和18B20采集温度,并用数码管显示(Use 51 And 18B20 collecting temperature and with digital display)
    2013-09-20 09:16:20下载
    积分:1
  • ctrl
    说明:  模糊PID控制器,解决了规则爆炸的问题,同时改善了系统的动态性能和实时性(Fuzzy PID controller to solve the rule explosion problem, while improving the system dynamic performance and real-time)
    2010-04-29 09:31:20下载
    积分:1
  • 7620
    飞思卡尔的风单片机源程序,希望有帮助哦,记得好好刊登在用看(Freescale wind microcontroller source code, hope helpful Oh, I remember the good published in see)
    2013-01-23 01:39:23下载
    积分:1
  • ucos
    99秒马表,在Proteus设计两个数码管动态显示及一个键盘SP。在ucos下结合keil完成开始时,显示“00”,第1次按下SP后就开始计时。 第2次按SP后,计时停止。第3次按SP后,计时归零。 (99 seconds stopwatch, two in the Proteus design dynamic digital tube display and a keyboard SP. Keil in combination ucos completed under the beginning of the show " 00" , 1st timer after pressing the SP. 2nd by SP, the time to stop. The 3rd by the SP, the time zero.)
    2009-06-30 11:06:00下载
    积分:1
  • SIM800C
    SIM800C升级工具,二次开发工具,省成本的特别好用用的方案(SIM800C upgrade tool)
    2017-01-23 11:27:01下载
    积分:1
  • sdfghjk
    基于正点原子stm32的频谱 a1读取ad信号显示(Punctuality atomic spectrum based stm32 a1 read signal display ad)
    2015-07-26 19:55:48下载
    积分:1
  • 696516资源总数
  • 106914会员总数
  • 0今日下载