Paradise3

舵机扫频辩识，鲁棒控制器，加载系统流量阀，双阀扫频(The sweep frequency identification, robust controller, loading system flow valve, double valve sweep )

avrmega16的频率计源码，在2m以内误差为1-3hz，1602显示(avrmega16 the frequency of source, in less than 2m error 1-3hz, 1602 show)

超精简的读写u盘程序，只有180行，可生成文件系统，估计再没有比这更短的程序了把？(Super-streamlined procedures to read and write u disk, only 180 lines, can generate the file system, it is estimated that more There is nothing short of the procedures?)

说明：  基于无功补偿控制器的MODBUS实现，用于高低压无功补偿控制器及其应用算法(Realization of Modbus based on reactive power compensation controller)

7128芯片设计原理图，适合3A一下电流的步进电机驱动器设计，非常实用(7128 chip design schematics for what current 3A stepper motor driver design, very practical)

基于LPC11U24，可实现 usart，的调用程序。(based on lpc11u24)

将J8,j13插上短路块，连接ISP下载器到学习板，将CS6-1.hex 文件下载到单片机，LEDMOD数码管将显示1234 数字！(The J8, j13 plug short-circuit blocks, connected to the learning board ISP downloader will CS6-1.hex file downloaded to the MCU, LEDMOD digital tube will display 1234 figures!)

stm32f103c8t6驱动DS18B20温湿度传感器程序源码(stm32f103c8t6,DS18B20)

hc08飞思卡尔单片机上实现ＡＤ转换，已完全调试通过(Freescale HC08 achieve single-chip AD conversion, debugging has been fully adopted)

真空机组先启动SK-30水环真空泵带压力降到6.5 KPa（此时真空机组的抽速是SK-30的抽速）启动ZJP-1200（此时真空机组的抽速是ZJP-1200抽速）待压力降到4 KPa启动ZJP2500（此时真空机组的抽速是ZJP-2500抽速）待压力降到1kpa时最后启动ZJP5000（此时真空机组的抽速是ZJP-5000抽速）到100Pa达到使用真空度时时就可以关闭机组(Vacuum unit first start SK-30 water ring vacuum pump with pressure drops below 6.5 KPa (pumping speed of the vacuum unit at this time is SK-30 pumping speed) start ZJP-1200 (pumping speed of the vacuum unit at this time is ZJP-1200 pumping speed ) until pressure drops below 4 KPa start ZJP2500 (pumping speed of the vacuum unit at this time is ZJP-2500 pumping speed) until the last start when pressure drops 1kpa ZJP5000 (pumping speed of the vacuum unit at this time is ZJP-5000 pumping speed) to 100Pa achieved using vacuum unit can be closed from time to time)