cPP-programing

描述材料热力的子程序 用于ABAUQS UMAT(Material thermal model)

一个基于应变的VUMAT一个复合材料板的的冲击损伤模拟A strain based VUMAT simulation of impact damage of a composite plate is presented(A strain based VUMAT simulation of impact damage of a composite plate is presented)

MSP430F149 例程，看门狗 C源程序代码。(MSP430F149 routine, the watchdog C source code.)

T5557卡的读写程序，KEIL4平台，曼彻斯特解码(T5557 card reader procedures, KEIL4 platform, Manchester decoding)

基于STM32F407系列芯片的，通过软件来模拟的IIC总线的主设备，读取MAC地址芯片里面的MAC地址。(Based on STM32F407 series chips through software to simulate the IIC bus master device reads the chip inside the MAC address MAC address.)

日本电波钟解码程序 接受长波信号并进行解码(JJY code)

说明：  看电子电路时序图如何看，这是个好方面，可以看看(Electronic circuit timing diagram to see how the look, this is a good side, you can see)

ESP8266，实现无线通信模块的传输,通过51单片机(ESP8266, realizing the transmission of wireless communication module)

说明：  AD7792的驱动程序，官方自带的0.0(AD7792 driver, official 0.0)

采用TI LaunchPad开发板触摸屏控制DAC7611输出电压(TI LaunchPad development board using the touch screen controls DAC7611 output voltage)