pso-toolbox

关于LDPC的。是Mackcy网站上的LDPC编译码程序。(On the LDPC. Mackcy site is LDPC coding and decoding procedures.)

turbo码的matlab仿真程序，仅供参考，希望对您有用(turbo codes matlab simulation program for information purposes only, hope useful to you)

直接序列扩频就是直接用具有高码率的扩频码序列在发端去扩展信号的频谱。而在收端，用相同的扩频码序列去进行解扩还原成原始的信息。(Direct Sequence Spread Spectrum is the direct use of the spreading code sequence with a high rate in the originator to expand the spectrum of the signal. Receiving end, using the same spreading code sequence to despread the broadening of the spread spectrum signal to restore the original information.)

用于图像处理等等，在MATLAB中实现移动目标的检测与辨识。(Used in image processing and so on, is realized in MATLAB moving target detection and recognition.)

常见的角度传感器的资料及选型，在选择角度传感器时可借鉴！(Common point of view sensor data and selection, the choice of angle sensor could draw!)

一个基于打靶法的最优控制求解软件 求解过程中采用参数延续算法 (A shooting method based on optimal control software to solve the process of solving the parameters used in the continuation algorithm)

常规波束形成器DOA估计算法 , Capon最小方差估计方法 , 多重信号分类(MUSIC)算法 的比较(' Conventional beamformer DOA estimation algorithm' , ' Capon minimum variance estimation methods' , ' multiple signal classification (MUSIC) algorithm' comparison)

独立分量分析算法（ICA）可以用于信号分解，数据处理等(Independent component analysis (ICA) can be used to decompose the signal, data processing)

采用matlab编写的对固定基座机器人动力学分析的程序，在simulink环境中运行。(Matlab prepared using a fixed base robot dynamic analysis procedures, in simulink environment.)

说明：  3GPP LTE中TS36942路径损耗模型的源程序代码(TS36942 3GPP LTE path loss model in the source code)