AD

单片机在电冰箱智能模糊控制中的应用(SCM in refrigerators Intelligent Fuzzy Control System)

基于ARM的俄罗斯方块设计，本次将设计实现一个用C语言编写的、在基于ARM核心的ADuC7020 ARM开发板上实现的单机版的俄罗斯方块小游戏。使用Keil3编程软件对C语言代码进行编写，支持按键操作，在实现过程中涉及了LCD液晶屏的图形显示、按键控制、LED控制、中断、蜂鸣器等嵌入式的编程技术。(Tetris ARM-based design, this will be designed to achieve a C language, the ADuC7020 ARM development board ARM core-based implementations of stand-alone version of the Tetris game. Use Keil3 programming software code written in the C language, support for key operations involved in the implementation process of the LCD screen graphical display, control buttons, LED control, interrupt, buzzer embedded programming techniques.)

说明：  将设备数字量的数据采集到MCU芯片中，以既定的mqtt格式由wifi模块连接路由器传输到服务器平台。(The data of device digital quantity is collected into MCU chip and transmitted to server platform by WiFi module connecting router in established mqtt format.)

串口看门狗模块的程序，通过定时如果规定时间内没有收到喂狗信号可以重开系统电源使其重起(Serial watchdog module procedures, through regular, if not received within the specified time signal can be re-opened喂狗system power so that it re-starting)

单片机联网的UIP协议程序，以及必要的驱动程序。(Networked microcontroller UIP agreement procedure, and the necessary drivers.)

基于51单片机制作的函数信号发生器，用DA0832和运算放大器来输出，单片机产生信号，用proteus仿真了（内含），能够产生正弦波，方波，锯齿波，三角波的波形。(51 single-chip microcomputer-based production function signal generator, used to DA0832 and the op-amp output, single-chip signal, proteus simulation with the (implicit), can produce sine, square, sawtooth, triangle wave.)

51单片机矩阵键盘的程序，线反转法，实现4*4键盘的读值。(51 single-chip matrix keyboard program, line reversal, 4* 4 keyboard reading.)

说明：  stm32+风速风向的测量，通过模拟量输入经过adc转换，测量风速及风向(STM32 + wind speed and direction measurement, through analog input through ADC conversion, measurement of wind speed and direction)

ADS131A02与DAC8552驱动代码(ADS131A02 and DAC8552 Driver Code)

参考ti提供得例子程序，先将他们得例子在自己得板子上跑起来，其实就是用自测试得方式来验证一下程序，也可以加些中断，看看程序怎么跑得。这步没问题得话，可以改写程序，当然还在自测试模式下先试，如果可以改写后，在自测试模式下可以。那么就差不多了，将自测试模式改成正常模式，将程序移植到自己得程序中，拿一个经过验证可以正常通讯得can模块通讯，记得两个can得速率要一致。当然这个can模块还要能让你看到或者说能验证你得can是否通讯正常。(Reference ti provide examples of procedures was, first they have to run up on the example of the board that she has, in fact, self-test was used to verify the program mode, you can also add some interruption to see how to run the program. This step was not a problem, you can rewrite the program, of course, still in test mode since the first try, if you can rewrite, can in self-test mode. Well almost, the self-test mode to normal mode, the program was ported to own program, get a proven module can communicate normally too can communicate, remember that two can get a rate to be consistent. Of course, this can also allow you to see the module or can verify whether you have can communicate properly.)