st16554

说明：  液晶模块的驱动范例，常用的例程，包内有多个程序，对单片机控制液晶模的编程有很大参考价值！(failed to translate)

通讯规则: 1:时钟7.3728 MHz/波特率9600/9个数据位/奇校验/1个停止位/硬件多机通讯功能/ 2:通讯连接采用硬件MAX485,双向单工 (Communication rules: 1: clock 7.3728 MHz/9600 baud/8 data bits/odd parity/1 stop bit/hardware, multi-machine communication/2: Communication connection using hardware MAX485, two-way simplex)

说明：  基于STM32F103和PS2遥控器的遥控小车程序(Remote control car program based on STM32F103 and PS2 remote control)

交换矩阵mt8816的c控制程序，可实现话音及图像的交换传输(Mt8816 exchange matrix of c control procedures, can realize the exchange of voice and image transmission)

在51单片机中用C语言描述IIC总线的功能，以LED发光二极管表现(51 single-chip using C language to describe the functions of the IIC bus, the LED light-emitting diode performance)

LabVIEW STM32103 VISA 串口示波器 6路AD采样 2路PWM输出 DIO 数字输入输出(LabVIEW STM32103 VISA Serial communication 2PWM out DIO Wavefrom)

说明：  TC275单片机基于autosar的bootloader工程代码(Bootloader engineering code of tc275 SCM based on AUTOSAR)

说明：  使用c语言开发51版的ADC功能与LCD功能。(51 written using c language version of the clock, can realize the normal timing)

说明：  内有PID源码驱动，包含位置式PID和增量式PID。PID通过结构体定义，可同时定义多套参数，并同时使用，并不会相互影响。(There is a PID source driver, including position PID and incremental PID.PID through the structure definition, can be defined at the same time multiple sets of parameters, and use at the same time, will not affect each other.)

带主动两轮主动差速的双电机PID调速模块，实现对电机的调速，尤其可以适用于对后轮双独立电机驱动方式的主动差速调节。(The dual motor PID speed regulation module with active two wheel active differential can realize the speed regulation of the motor, and can be applied to the active differential regulation of the driving mode of the dual motor of the rear wheel.)