InputMethodManager

nrf905 接收机程序 89C52 验证通过 绝对好使(nrf905 receiver program 89C52 verified through absolutely so)

Arduino LCD library

在SMT32F7平台上的基于FreeRtos系统的Lwip1.4的移植(Transplantation of Lwip1.4 Based on FreeRtos System on SMT 32F7 Platform)

说明：  ADC采样电压值，显示波形，通过FFT计算频率，双通道ADC，最高500K，100K不失真(ADC Samples Voltage Value and Displays Waveform)

动力电池保护板程序,包括主程序，IIC,定时器，ADC(Power battery protection board procedures, including the main program, IIC, timer, ADC)

说明：  ec20通信基于stm32单片机，MQTT协议连接移动的onenet平台。(EC20 communication is based on STM32 single chip microcomputer, mqtt protocol connects the mobile onenet platform.)

MSP430单片机C语言应用程序设计实例精讲(MSP430 microcontroller C language application design example succinctly)

CRF 准确率、精确率、召回率、F值计算程序(CRF accuracy, precision, recall, F value calculation program)

最全面的18b20中文参考手册，是目前最全面的，包含了18b20的所有资料(The most comprehensive 18B20 Chinese reference manual is the most comprehensive one at present, which contains all the materials of 18b20)

这是一个基于STC单片机，采用分离原件的125K的ID读卡器全套设计资料，其中包括原理图、PCB以及单片机源程序，还有我做设计时的参考资料。内容很全面的，以及在实物上验证过，可以正常运行。主要使用的天线为820uH。(This is based on STC microcontroller, the separation of the original 125K ID card reader full design information, including schematics, PCB and microcontroller source code, as well as I do the design reference. Content is very comprehensive, and verified on the kind, can operate normally. The main antenna is 820uH.)