New-Folder-(2)

chi-square testing for lognormal distribution

2兆瓦异步双馈风力发电系统的建模与仿真，包含个子模块。pitch信号自己添加。。(2 MW doubly fed induction wind power system modeling and simulation, including the sub-modules. pitch signal to add their own. .)

模糊PID控制的matlab仿真模型，已通过试验，课成功运行，主要是用来控制机器人自动导航。(Matlab simulation model based on fuzzy PID control, has passed the test, lesson successful operation, is mainly used to control the robot autonomous navigation.)

matlab cstr implmentation using state estimation

本演示实现了主动轮廓模型由Kass等人提出。 要运行它的图形用户界面 1。基于MATLAB型引导提示。 2。关于“到现有的图形用户界面，点击” 3。选择在与本文件相同的目录snk.fig文件 4。按一下上方的绿色箭头启动图形界面 一旦GUI已经启动，您可以通过使用蛇 1。点击“新形象”，并加载输入图像。提供的样品图像。 2。平滑参数设置“西格玛”或保留其默认值并点击“过滤器”。这将平滑图像。 3。只要你点击“过滤器”，头发会出现交叉，用他们和你左击鼠标，您可以选择在图像上的初始轮廓的位置。会出现一个红色圆圈到处您单击并在多数情况下，你应该单击对象周围的一切你想要的部分。最后一点，必须挑选使用右键单击，以阻止更多的积分为MATLAB的要求。 4。设置各种蛇参数（在能源方面的相对权重的蛇目标函数）或离开它们的默认值，然后按一下他们“迭代”按钮。蛇会出现和移动，因为它收敛到它的低能量状态。(This demo implements the Active Contour Models as proposed by Kass et al. To run it with GUI 1. Type guide on the matlab prompt. 2. Click on "Go to Existing GUI" 3. Select the snk.fig file in the same directory as this file 4. Click the green arrow at the top to launch the GUI Once the GUI has been launched, you can use snakes by 1. Click on "New Image" and load an input image. Samples image are provided. 2. Set the smoothing parameter "sigma" or leave it at its default value and click "Filter". This will smooth the image. 3. As soon as you click "Filter", cross hairs would appear and using them and left click of you mouse you can pick initial contour location on the image. A red circle would appear everywhere you click and in most cases you should click all the way around the object you want to segment. The last point must be picked using a right-click in order to stop matlab for asking for more points. 4. Set the various snake paramete)

SPIHT的一个Matlab程序，经过改进的。2006年编写的。(SPIHT, a Matlab procedure improved. Prepared in 2006.)

二.十 六进制的转化过程及源代码 kfaf afk a(two. 10. Hexadecimal transformation process and the source code kfaf afk a)

This creates a trapezoid wave, similar to the built-in square function but with no duty cycle option

matlab编写的点阵计算程序,用于阵列全息光镊的计算(spot array calculation)

principal Component analysis help to change the principal axis