target-track

THIS FILE IS PART OF THE OggVorbis SOFTWARE CODEC SOURCE CODE.

关于边缘检测的matlab程序，设置初始点，调试用的初始化等等(About matlab edge detection procedure, set the initial point, debugging and so on used to initialize)

说明：  基于主成分分析实现对特征脸的人脸识别，训练，输出识别率等。(Based on principal component analysis to achieve the characteristics of face recognition, training, recognition rate of the output.)

说明：  所传为共轭梯度法和线性加权法，这两种方法在优化中有较大的作用！(The transfer to the conjugate gradient method and linear weighted method, the two methods in optimization have a greater role!)

说明：  无线传感器网络路由算法，采用最短路径，先搜索节点的一跳范围的距离，再搜索两跳的距离，仿真效果良好。(Wireless sensor network routing algorithm, using the shortest path first jump of the scope of the search node distance, and then search for the two jump distance, simulation results were very good.)

Direct torque control of an asynchrone machine

Digital Signal Processing, developped in matlab short examples for processing

说明：  实现贝叶斯分类器,在matlab上的源代码(Bayesian classifier in matlab source code)

基于matlab的激光课程设计，例子，福克斯里迭代法对矩形腔激光器，圆形镜面激光器等的仿真。(laser design)

杜芬振子相轨图在利用混沌处理机械故障微弱信号应用Duffing相轨(Duffing oscillator with mechanical failure orbit map at a weak signal processing phase Duffing orbit)