gdc_v1.0

Matlab在分形模拟上的一些应用！根据程序中迭代的选取，将分形模拟分为确定迭代法和随机迭代法。(Fractal Simulation on Matlab in some applications! According to the procedure in the iterative selection fractal simulation is divided into established and the random iteration method iterative method.)

找了好久，才找到这个mctoolbox,功能很强大(i am looking for a long time mctoolbox)

matlab NSS利率期限模型源代码 用的是非线性最小二乘法 里面有两种实现方法(matlab NSS Term model source code using a nonlinear least squares method, there are two ways to achieve)

标准程序源代码标准程序源代码标准程序源代码(biao zhun cheng xu yuan daima)

This code is used to find the matrix converter result fir improving the active and reactive power

DCT and Image Compression In the JPEG image compression algorithm, the input image is divided into 8-by-8 or 16-by-16 blocks, and the two-dimensional DCT is computed for each block. The DCT coefficients are then quantized, coded, and transmitted. The JPEG receiver (or JPEG file reader) decodes the quantized DCT coefficients, computes the inverse two-dimensional DCT of each block, and then puts the blocks back together into a single image. For typical images, many of the DCT coefficients have values close to zero these coefficients can be discarded without seriously affecting the quality of the reconstructed image. The example code below computes the two-dimensional DCT of 8-by-8 blocks in the input image, discards (sets to zero) all but 10 of the 64 DCT coefficients in each block, and then reconstructs the image using the two-dimensional inverse DCT of each block. The transform matrix computation method is used.

无线定位代码，包括各种定位算法的基本函数，定位算法包括TDOA、TOA、AOA等(Wireless location code, including the basic function of a variety of localization algorithm, localization algorithm, including TDOA, TOA, AOA, etc.)

FIR带通滤波器的设计程序，参数见程序内容(FIR band-pass filter design, process parameters, see)

lsb算法将水印图像按最不重要位(LSB)方法嵌入到载体图像中，在把水印从载体图像中提取出来(This is a LSB algorithm that embedding watermark into the least important part of the primary image, and the watermark can be extracted from the primary image.)

MATLAB信号系统教程含源码测试通过 复制代码到.m文件即可 (MATLAB Signal System tutorials with source code to the test by copying. M files can)