SNAKE

3σ准则 利用LabVIEW编写 剔除粗大误差(to Elimitate the gross error)

信号发生器，带扫频，带频率的切换！最小可以0.1HZ。(Frequency sweep signal generator, belt, belt frequency switch! Minimum to 0.1 HZ.)

对振动信号采集和分析，包括信号采集，时域分析，品与分析 故障定位(Vibration signal acquisition and analysis)

labview通讯案例，多线程一对多，实现多线程通讯(labview review eefefeffffffff adkadaapadadkada)

这是一个在labview上根据悬臂梁厚，梁长，受力点距固定端的长度，应变片距固定端的长度，以及应变片上的数值来测算梁的最大挠度的程序。( This is a distance in the labview according thick cantilever beam length, the length of the pitch by the force of the fixed end, the fixed end of the length of the strain gauge and strain values on-chip to measure the maximum deflection of the beam of the program.)

利用LABVIEW开发的，可进行连续信号采集的程序(A program developed by LABVIEW for continuous signal acquisition)

基于LABVIEW的鼠标双击时间间隔的测量(Double click the time interval measurement )

单向的BOOST PFC电路，是连续模式的，可以使用。控制策略为电压电流双环控制(Boost PFC for MATLAB)

串口自动换算CRC代码，编写时直接可以调用(Serial port automatically converts CRC code, which can be called directly when writing.)

使用labview制作而成的网页浏览器，输入网址即可打开网页(Web browsers made with LabVIEW)