ZB220GDNZ_PSR

51单片机的闪烁灯代码一，非常适合初学者的使用，在这分享给大家。(51 MCU flashing lights code, very suitable for beginners to use, in this share to everyone. )

自动交通控制系统用红、绿、黄三支共两组发光二极管表示交通信号灯，利用单片机模拟有时间显示的定时交通信号灯控制管理。信号灯的变化规律可如下： 1）放行线：绿灯亮放行25秒，黄灯亮警告5秒，然后红灯亮禁止。 2）禁示线：红灯亮禁止30秒，然后绿灯亮放行。 3）当某一方向的红灯亮时，若该方向有车通过，则用扬声器声报警。（撞红灯信号可用3-5V模拟量表示）(Automatic traffic control system using red, green, yellow light-emitting diodes, said a total of three traffic lights, the use of single-chip analog time display on a regular traffic signal control and management. Changes of lights to be as follows: 1) Release Line: green clearance 25 seconds, the yellow light warning for 5 seconds, then the red light is prohibited. 2) ban shows lines: the red light is prohibited for 30 seconds, then the green light to release. 3) When the red light in one direction, if the direction of the car through, the alarm speaker sound. (Hit the red signal available 3-5V analog representation))

通过51单片机设计一个电子时钟，精确到秒，可以通过按键调节时间(By 51 microcontroller design an electronic clock, accurate to seconds, you can adjust the time by pressing a button)

用Visual C++ 6.0实现的一个VSP程序。包你看后受益匪浅。(with Visual C 6.0 of a VSP procedures. After looking at the package you benefited.)

RAID卡的测试程序，写的不好哈，请大家原谅，(RAID card test procedures and writing bad Kazakhstan,)

电子时钟程序，简洁明了，原创请勿抄袭 适用于stc15单片机(Electronic clock program)

电子时钟的小程序，基于89c51单片机，可以实现定时、计时、修改时间等功能。(Electronic clock applet, based on 89c51 microcontroller, can achieve timing, timing, modification time and other functions.)

关于stm32的485通讯程序，用串口USART。。。(stm32-485 program)

ACR9000多轴运动控制器上位机控制程序示例（MFC） (ACR9000 multi-axis motion controller PC control program example (MFC))

说明：  MCU 52 单片机控制程序，主要功能是日历时钟显示函数控制函数的算法。(MCU 52 microcontroller control program, the main function is to control the function of the calendar clock display function, the algorithm.)