pegasisSSS

雷达信号处理的工具箱，很有用啊，大家快来下载吧(Radar signal processing toolbox, useful ah, everyone Come download bar)

Implementacao da rede MLP canonica (backpropagation com gradiente descendente)

一种智能优化算法-模拟退火算法的matlab源程序(simulated annealing)

分别对线性调频信号、非线性调频信号、连续波信号、频率编码信号和相位编码信号的进行了信噪比特性分析，较为有用的程序，与大家分享(Chirp signal, non-linear FM signal, continuous wave signal frequency coded signal and phase encoded signals were signal-to-noise ratio characteristic analysis, a more useful program, to share with you)

光伏并网逆变器SIMULINK仿真程序，采用双闭环PI调节，并且加入重复控制(PV ,simulink ,repetive control, PI)

说明：  这是我自己改进的语音信号处理里面的，基于谱减法的语音处理，不仅适合初学者研究还适合有一定基础的研究者使用！(This is my own voice signal processing to improve inside, based on spectral subtraction for speech processing, not only for beginners study also have some foundation for researchers to use!)

说明：  The model used for creating the reference voltage is shown in Fig. 4. First, photovoltaic output current (Ipv) and output voltage (Vpv) are passed through a first order low pass filter with a magnitude of G = 1 and a time constant of T = 0.01 seconds in order to filter out the high frequency components or harmonics from these signals as shown in Fig. 5 and Fig. 6. The filtered current and voltage signals (Ipv_F and Vpv_F) are then fed into the MPPT control block that uses the Incremental Conductance Tracking Algorithm. An algorithm that is based on the fact the slope of the PV array power curve shown in Fig. 7 is zero at the Maximum Power Point (MPP), positive on the left of the MPP, and negative on the right. The MPP can thus be tracked by comparing the instantaneous conductance (I/V) to the incremental conductance (∆ I/∆ V) [11] as in (1):

matlab写的一个随机共振的例子MALAB 中可以可以仿真( a stochastic resonance wrote BY Matlab, example can can simulation IN MALAB )

adaptive total variation estimation for the point spread function

数字预失真的LS算法，利用LS算法提取预失真参数(LS digital pre-distortion algorithm, using LS algorithm extracts the predistortion parameters)