CertificationRequest

《 单片机应用技术(C语言版)(工业和信息化高职高专“十二五”规划教材立项项目)》素材文件 (" SCM technology applications (C language) (Industry and Information Technology College" 12th Five-Year Plan " textbook project project) material file)

关于一个滑块显示的程序，可以通过滑块调整实现各种功能(About a slider and its function)

基于STM32的定时器的一些简单开发和应用(Simple development application of STM32)

说明：  AT89S51demo代码，方便快速开发(AT89S51demo Code, Convenient and Rapid Development)

2005全国大学生电子设计E悬挂运动控制系统论文(2005 National Undergraduate Electronic Design E hoisting motion control system papers )

硬件资源: 1,DS0(连接在PA8)，DS1(连接在PD2上) 2,串口1(波特率:115200,PA9/PA10连接在板载USB转串口芯片CH340上面) 3,ALIENTEK 2.8/3.5/4.3寸LCD模块(仅支持MCU屏) 4,按键KEY0(PC5)/KEY1(PA15)/KEY_UP(PA0,也称之为WK_UP) 实验现象: 通过按键KEY_UP可以控制定时器AutoReloadTimer_Handle的开启，这个是 周期定时器，一旦开启就会不断的运行，直到按下KEY1将其关闭。按下KEY0 可以打开定时器OneShotTimer_Handle，这是个单次定时器，只会运行一次， 运行周期到了以后就会停止运行，除非按下按键KEY0将其再次开启。(Hardware resources: 1, DS0 (connected to PA8), DS1 (connected to PD2) 2. Serial port 1 (baud rate: 115200, PA9/PA10 connected on board USB to serial chip CH340) 3, ALIENTEK 2.8/3.5/4.3 inch LCD module (only supporting MCU screen) 4. Keyboard KEY0 (PC5)/KEY1 (PA15)/KEY_UP (PA0, also known as WK_UP) Experimental phenomena: The timer AutoReloadTimer_Handle can be turned on by keying KEY_UP. This is The periodic timer will run continuously once it is turned on until KEY1 is pressed to turn it off. Press KEY0 You can turn on the timer OneShotTimer_Handle, which is a single timer and only runs once. The run cycle will stop after that unless KEY0 is pressed to turn it on again.)

PX4FLOW光流传感器的源码，包含stm32f4系列处理器、声纳模块、摄像头模块、串口模块等源码。(PX4FLOW optical flow sensor of source, including stm32f4 series processors, sonar module, camera module, serial module and other source.)

不错的拓普微3.5寸LCD显示屏驱动代码，可以参考(Good TOPWAY 3.5-inch LCD display driver code, you can refer to it)

buck电路，非常规的buck电路，参数可自由修改(buck circuit)

pcf8563 lcd1602 ds18b02 stc89c52rc对系统精确定时 报警 采集温度(pcf8563 lcd1602 ds18b02 stc89c52rc precise timing of the alarm system collected temperature)