plating

一个二维的fdtdc++编写的程序，较完整，带有pml边界条件。感兴趣的可以下载看看。(A two-dimensional fdtdc++ preparation procedures, more complete, with pml boundary conditions. Interested can download to see.)

RTW方面的文献,对vc和matlab混合编程有很好的借鉴意义(RTW literature)

在matlab上运用有限时域差分法模拟二维光子晶体(the simulation of tm mode in two-dimensional photonic crystals using FDTD)

Implementation of the ISO15693 Protocol in the TI TRF796x

数据链路层滑动窗口协议的设计与实现源码 信道模型为8000bps 全双工卫星信道，信道传播时延270 毫秒，信道误码率为10-5，信道提供字节流传输服务，网络层分组长度在240~256字节范围。(Sliding window data link layer protocol design and implementation of source-channel model 8000bps full-duplex satellite channel, the channel propagation delay 270 ms, the channel bit error rate of 10-5, the channel provides a byte stream transfer service, network layer packet length in the range of 240 to 256 bytes.)

使用VC创建Matlab数组、删除数组，进行二次编程(Matlab using the VC to create an array, delete array, a second program)

波前曲扭和幅度变化对阵列测向中相干源分辨的影响(Twisted and curved wavefront amplitude variation to distinguish the impact of coherent source direction finding in an array)

由设计要求可知，wp<=0.2π，允许误差幅度小于1dB，ws>=0.3π内衰减应大于15dB。为了验证数字滤波器的实际滤波功能，设计程序时，把输入序列定为验证函数x（t）=4sin（100πt）以及x（t）=4sin（200πt）和x（t）=4sin（400πt）。又因为Ts=1.25ms，T=80ms，故采样点为64，即N=64，所以当M=6，可以同时调试并验证程序的滤波功能。(Seen by the design requirements, wp < = 0.2π, allow a margin of error of less than 1dB, ws> = 0.3π within attenuation greater than 15dB. In order to verify the actual filtering function of the digital filter design program, the input sequence as validation function x (t) = 4sin (100πt) and x (t) = 4sin (200πt) and x (t) = 4sin (400πt) . And because Ts = 1.25ms, T = 80ms, so the sampling points is 64, that is N = 64, so when M = 6, can debug and validate filtering program.)

捷联惯导系统仿真算法的研究及其实现.nh.大连理工大学硕士论文，详细阐述了如何用matlab-simulink进行惯导仿真(Strapdown inertial navigation system simulation algorithm and its realization. Nh. Dalian University of Technology master s thesis in detail how to use matlab-simulink simulation for INS)

中大数计的matlab的ppt,数学建模竞赛资料(The large numbers of dollars matlabppt)