GA

数据链路层滑动窗口协议的设计与实现源码 信道模型为8000bps 全双工卫星信道，信道传播时延270 毫秒，信道误码率为10-5，信道提供字节流传输服务，网络层分组长度在240~256字节范围。(Sliding window data link layer protocol design and implementation of source-channel model 8000bps full-duplex satellite channel, the channel propagation delay 270 ms, the channel bit error rate of 10-5, the channel provides a byte stream transfer service, network layer packet length in the range of 240 to 256 bytes.)

matlab与VC的图像处理的混合编程源代码,如果对于混合编程有兴趣的人这是不可多得的好程序!(matlab image processing and VC hybrid programming source code, if there is interest for mixed programming of the people This is a rare good program!)

此程序能够完成对电容元件的几何特性自适应测量。(This program can complete the adaptive measurement of geometric characteristics of the capacitor element. )

数字移动:图中的九个点上,空出中间的点,其余的点上任意填入数字1到8.1的位置固定不动,然后移动其余的数字,使1到8顺时针从小到大排列.移动的规律是:只能将数字沿线移向空白的点. (Digital Mobile: Figure in the nine points, empty out the middle point, the rest of the points fill any position of the numbers 1 to 8.1 fixed and then move the rest of the figures, and make 1-8 clockwise from small to large array . The law of movement is: can only move along the number of blank spots.)

Window网络与通信 书的配套源码(Window networking and communications supporting the FO)

自适应滤波的MATLAB实现现，包括lms rls 等算法 (MATLAB realization of the adaptive filter is lms rls algorithms such as)

~~~~~~~为初级学者使用的遗传算法~~~~~~~~~~~~(Genetic Algorithms for Primary learner)

this is a folder containing algorithms and source codes for face recognition

自己写的一个机器人matlab仿真程序。程序实现了六自由度旋转关节机器人的运动学、动力学仿真和轨迹规划。机器人初始关节变量以xls文件形式导入程序中，也可在程序中拖动滑块修改。(robot simulate by matlab , kinematic & dynamics&trajectory.)

本代码实现了matlab调用VC的动态链接库与cypress的68013芯片通过usb进行数据交换(Matlab code implements the dynamic link library called VC and cypress in the 68013 chip data exchange via usb)