(6)

控制数字控制柜去控制线切割机床。具体点说功能有三点，其一导入已画好的CAD图形（二维图形），其二LabVIEW识别图形并导出CAD图形的X-Y坐标，其三向单片机发送X-Y坐标。(Control of digital controller to control wedm. Specifically function has three, one of the import has good CAD graphics (2 d graphics), the second LabVIEW identify graphics and export x-y coordinates of CAD graphics, thirdly send MCU x-y coordinates.)

定时器扫描矩阵键盘，让你彻底摆脱delay(Timer scan matrix keyboard, let you completely get rid of delay)

ATMEGA48 头文件 适用于 ICCAVR7.0 有些版本没有ATMEGA48的头文件(ATMEGA48 )

EEPROM读写实例，可直接写到STC12C5616AD烧写板子上的C程序(Instance can be directly read and write EEPROM programming board wrote STC12C5616AD C program)

常见的单片机操作，IO，中断，定时器，低功耗模式等(io, interrupt, timer, low power mode and so on)

利用51单片机做的一个闹钟程序，可以自己设定闹铃时间(err)

saber软件搭建的BUCK双闭环控制模块，电流内环和电压外环，直接能用。(saber software built BUCK double-loop control module, the current inner and outer voltage, can be used directly.)

基于At89c52和数码管实现的秒表，具有正向计时、倒计时和清零功能，三个按键分别对应k1（开始计时、暂停、继续）、k2（倒计时、暂停、继续）、k3（停止、归零）。文件包括源码、工程文件、仿真原理图和工程文件。(Based At89c52 and implement digital stopwatch, has a positive time, countdown and clear function, three buttons corresponding to k1 (start time, pause, resume), k2 (countdown, pause, resume), k3 (stop, zero ). File contains the source code and schematics.)

to run lcd n96 320*240pixle with lpc1768

搭建onvif设备端代码 非常有用，可以配合ONVIF Device Manager测试(Device-side code to build onvif)