SSBoll79

供初学空时编码（vblast接收）的matlab仿真程序，是关于vblast接收中ML算法的简单的仿真(for novice space-time coding (vblast receiver) Matlab simulation program, on the ML vblast Receiving a simple algorithm simulation)

几乎所有图论问题的matlab和Lingo程序，包括经典的遗传算法，模拟退火，最小prim生成树等，程序中有详细讲解。(Graph theory problem matlab and Lingo program, explain in detail the procedures.)

matlab数值分析线性方程组严格对角占优，选主元计算程序(Matlab numerical analysis of linear equations strictly diagonally dominant, pivoting calculation program)

潮汐调和分析 利用t-tide程序对实测数据资料进行的潮位调和分析 求出调和常数(Tidal harmonic analysis procedure using t-tide data for the measured harmonic analysis of tidal harmonic constants obtained)

先生成这样的一幅500*500的RGB彩色图像：一个田字格，左上和右下是绿色，右上是红色，坐下是蓝色。并进行如下处理：（a）将该图像转换到HSI空间，用25*25的平均模板模糊H分量图像，再转换回RGB空间；（b）重复（a），只是这次处理的是S分量。最后简单分析结果。（内含实验报告） (Mr. into a 500* 500 RGB color image: a field word lattice, the upper left and lower right is green, the upper right is red the sit is blue. And be handled as follows: (a) the image into the HSI space, fuzzy H 25* 25 average template component image, and then converted back to RGB space (b) Repeat (a), only this time to deal with the S component . Finally, a simple analysis of the results. (Contains experimental report))

This will give you some tips on how to build a gui using matlab, PDF file

Calculation of near field and far field Radiation pattern

说明：  用DFT计算连续信号的谱 通过应用 DFT 进一步加深对离散信号 DTFT 和 DFT 的概念及其相互关 系的理解。 =利用 DFT 计算连续周期信号的频谱(DFT calculations using a continuous signal by applying the DFT spectrum of discrete signals to further deepen the concept of DTFT and DFT and their mutual understanding of the relationship. = DFT calculations using a continuous spectrum of periodic signals)

解决最小费用最大流问题，一般有两条途径。一条途径是先用最大流算法算出最大流，然后根据边费用，检查是否有可能在流量平衡的前提下通过调整边流量，使总费用得以减少？只要有这个可能，就进行这样的调整。调整后，得到一个新的最大流。(Minimum cost maximum flow problem to solve, there are generally two ways. One way is to use a maximum flow algorithm to calculate the maximum flow, then the cost side, check whether it is possible under the premise of the flow balance by adjusting the edge flow, so that the total cost can be reduced? As long as this possible, for such adjustments. Adjusted to obtain a new maximum flow.)

matlab code generates egarchmodel