登录
首页 » matlab » fengshanchukoucanshu

fengshanchukoucanshu

于 2013-09-22 发布 文件大小:2KB
0 244
下载积分: 1 下载次数: 11

代码说明:

  可以计算出航空发动机的风扇及其相关部件的相关参数(Can be calculated fan of aircraft engines, the relevant parameters and associated components)

下载说明:请别用迅雷下载,失败请重下,重下不扣分!

发表评论

0 个回复

  • space_time_coding
    空时编码,很全很好的代码哦,所有空时的编码方法都包含了(Space-time coding)
    2010-05-17 20:12:56下载
    积分:1
  • improvedProny1
    this is improved prony method that is very strengs for noisy signal
    2021-05-08 18:58:35下载
    积分:1
  • Histogram-equalization
    直方图均衡法的MATLAB图,经过测试没有问题,绝对可以用,做图像的同学可以用来参考.大家可以下载下来在MATLAB中运行试试(Histogram equalization method of MATLAB figure, after test no problem, absolutely, can be used to do image can be used for reference)
    2013-12-21 22:59:47下载
    积分:1
  • nonlinear
    NONLINEAR LOAD DEMONSTRATION FOR LABORATORY TYPE RECTIFIER
    2014-02-04 19:42:09下载
    积分:1
  • Alamouti_STBC_2Tx1Rx
    Script for computing the BER for BPSK modulation in a Rayleigh fading channel with Alamouti Space Time Block Coding Two transmit antenna, 1 Receive antenna
    2011-10-02 08:05:32下载
    积分:1
  • lsc-code
    metric learning using this for manifol learning
    2013-04-09 19:50:10下载
    积分:1
  • Untitledzuidashangdafudu
    用于地波雷达电离层污染校正,主要在污染幅度大的情况下用(radar signal processing)
    2013-11-22 16:49:52下载
    积分:1
  • grd_test
    xwch_test.m是主测试文件;biaoji.mat存放滤波器系数;xiangweicha.m用FFT计算相位差。 仿真框架为: 1.标记信号和双音信号续接作为发送信号; 2.对双音中一个频率分量的相位做偏移,再经过一个低通滤波器(引入线性相位,模拟收发不能同步测量现象)后,作为收到的信号; 3.用一个检测信号对收发信号进行相关运算; 4.画出收发信号以及相关处理后的信号。找出相关信号的那个尖点,从而推算出收发双音信号0相位点; 5. 输入0相位点位置,计算相对相位差。(xwch_test.m is the main test file biaoji.mat store filter coefficients xiangweicha.m calculated using FFT phase difference. Simulation framework: 1. Mark signals and then as a two-tone signal continued to send signals 2. On a two-tone frequency components of the phase shift to do, and then through a low pass filter (the introduction of linear phase, simulation can not simultaneously send and receive measuring the phenomenon), the as received signal 3. using a detection signal of the transceiver signal correlation operation 4. draw send and receive signals and related processed signal. Correlated signal of the cusp, which calculate the two-tone signal transceiver 0 phase point 5. Enter 0 phase point position, calculate the relative phase difference.)
    2010-06-12 17:31:00下载
    积分:1
  • blind3sub
    说明:  利用子空间方法实现盲信道均衡的matlab程序,给大家个参考(Subspace method for blind channel equalization to achieve the matlab program, give us a reference)
    2010-04-30 00:11:48下载
    积分:1
  • matlab
    多输入BP神经网络的几个例子,主要包含函数拟合以及最小二乘法(matlab bp)
    2013-03-12 16:42:46下载
    积分:1
  • 696516资源总数
  • 106914会员总数
  • 0今日下载