Housingforecast

shows how signals work in plots complex signal A*(sin(w)+cos(w))

create a structure element to use in the mathematical morphology

Fonction to calculate autocorrelation for matlab version before 2010

matlab程序，FFT变换matlab程序，有助于初学者学习(matlab program，it will help u to study)

平面磨床电永磁磁盘控制用电压调节程序，输入AC380V变DC220V电压输出。(Magnetic disk surface grinding machine with voltage regulation control program, enter AC380V change DC220V voltage output.)

camera UAV Gimbal matlab

Little programs on matlab.

说明：  任务：设计一个4×2.5Gbit/s 长距离光纤传输系统，并利用OptiSystem 仿真验证。 要求： 1．采用波分复用技术，波长设置以100GHz 为间隔，频率分别为193.1THz、193.2THz、193.3THz、193.4THz，每个波长传输速率为2.5Gbit/s（NRZ），传输距离为300km。采用常规光纤，光纤损耗系数为0.25dB/km。 2．单通道光发送机最大输出功率为0dBm，光接收机的接收光功率不低于－26dBm，过载点为－10dBm。 3．可以采用EDFA 作为线路放大器，其中EDFA 的输入功率限制在－18～2dBm，最大输出功率20dBm，增益范围为13～25dB，噪声指数4.0dB。(Task: Design a 4 x 2.5 Gbit/s long-distance optical fiber transmission system, and use OptiSystem simulation to verify. Requirement: 1. Using wavelength division multiplexing technology, the wavelength is set at 100GHz intervals, with frequencies of 193.1 THz, 193.2 THz, 193.3 THz and 193.4 THz, respectively. The transmission rate of each wavelength is 2.5 Gbit/s (NRZ), and the transmission distance is 300 km. The loss coefficient of conventional optical fibers is 0.25dB/km. 2. The maximum output power of a single-channel optical transmitter is 0 dBm, and the receiving power of an optical receiver is not less than -26 dBm, and the overload point is -10 dBm. 3. EDFA can be used as line amplifier, where the input power of EDFA is limited to - 18-2dBm, the maximum output power is 20dBm, the gain range is 13-25dB, and the noise index is 4.0dB.)

多元线性回归,包含了具体的检验系数和输入输出，很有用(MultiLineRegression)

用matlab编写的simulink模块的设计(Written by matlab simulink Module)