ARRAY

【谷速软件】二维图像Gabor滤波源代码 可以做为参考使用 ([Valley] speed two-dimensional image Gabor filtering software source code can be used as a reference to use)

幂法求特征值的matlab设计，针对所有矩阵(Power law seeking eigenvalues ​ ​ matlab design for all matrices)

语音信号进行分析、处理和设计。用MATLAB做变声器的原理是通过改变输入声音频率，进而改变声音的音色、音调，使输出声音在感官上与原声音不同。变声器是借助对声音音色和音调的双重复合改变，实现输出声音的改变。通过自己发声，共振峰频率的改变是基于重采样实现的(Speech signal analysis, processing and design. MATLAB do voice-changer works by changing the input frequency of the sound, and then change the sound of the tone, pitch, so that the output audio with the original sound in different senses. Voice Changer is the use of sound timbre and tone of the dual composite changes, realize the output sound changes. Through their own sound, formant frequency change is implemented based on resampling)

实现频控发射控制与接收，属于雷达MIMO研究的新领域，SCI研究热点(Realization of Frequency Controlled Transmitting Control and Receiving)

编程仿真连续小推力实现GTO到GEO的三阶段转移过程，其中推力器的推力大小为0.8N，轨道机动的起始点为GTO的远地点。GTO轨道的升交点赤经为0度，近地点角距为90度。 GTO轨道： ph:185km，ah：35786km，i：28.5°，GEO轨道：h：35786km，i：0°。 卫星质量为6600kg，从GTO到GEO，采用5000s的推力器。取地球半径为6378km，g取值为9.8m/s^2(The three stage transfer process from GTO to GEO is realized by simulation and continuous small thrust. The thrust of the thruster is 0.8N, and the starting point of orbital maneuver is the apogee of GTO. GTO orbit RAAN is 0 degrees, 90 degrees for the argument of perigee. GTO orbit: ph:185km, ah:35786km, i:28.5, GEO orbit: h:35786km, i:0. The mass of the satellite is 6600kg, from GTO to GEO, using the 5000S thruster. The radius of the earth is 6378km, and the value of G is 9.8m/s^2)

说明：  MATLAB编写的有关数学问题的数学函数优化程序，即求函数极值问题的相关程序(MATLAB solving physics problems of extreme values with mathematics)

说明：  遗传偏最小，是上面师兄传下来的，我不大会用(Genetic partial least, is the top senior passed down, I do not use the General Assembly)

关于sar原始数据压缩的算法分析 希望对大家有帮助(about sar row data)

说明：  流体计算传热计算代码，matlab编写的流体力学计算和传热计算程序。-matlab prepared CFD and heat transfer (The Flow of Heat Transfer Calculation Code)

说明：  关于定时同步的Matlab仿真代码，采用锁相环技术实现(Matlab code for Timing recovery using PLL)