LS_test

这是使用Labview实现I2C通讯的程序，很好的算法，通讯速率会很快。(This is the use of Labview realize I2C communication procedures, a good algorithm, communication speed very fast.)

说明：  求解广义非线性薛定谔方程的频移方程 与分步傅里叶法不同，解决了非线性系数随波长变化的问题(Solving the frequency shift equation of GNLSE)

说明：  通过串口解析MODBUS协议 读开关量型的输入信号 读保持寄存器上的内容 批量写数据到保持寄存器(Resolving MODBUS Protocol through Serial Port Input signal of reading switch type Read and hold registers Write data in batches to hold registers)

uwb高斯脉冲的产生程序，请大家参考给个意见(UWB Gaussian pulse of procedures, please refer to the comment! ! ! ! Thank you)

说明：  本文件是基于高斯正弦波行的宽带脉冲波形设计,保证了相对带宽大,衰减满足3db要求(this document is based on the Gaussian line broadband sinusoidal pulse waveform design, ensuring a relatively large bandwidth. attenuation meet the requirements Z)

c++ source fft ifft 2-d FFT ofdm

本源码包参考英国Southampton大学Robert G. Maunder教授2008年的EXIT charts开源demo，给出了通用(分量码多项式可自定义)并行级联Turbo码的EXIT charts的作图源码。同时可完成迭代轨线、BER等值线的绘制等工作。 由于对于码块长较大的情形仿真需要较长时间，源码包也给出了部分分量码多项式的仿真结果，可直接用于绘图。 源码包还给出了最经典的S.Ten Brink介绍EXIT charts基本原理的参考文献，以及本人对通信系统中迭代译码过程分析技术综述的小论文，希望对大家有所帮助。(This source package comes after Professor Robert G. Maunder s open source demo about EXIT charts in 2008 from University Southampton, UK. It is designed for universal (constituent code generation polynomial can be customized) Parallel Concatenated Turbo Code EXIT charts. The iterative trajectories and BER contour drawing is also completed in this package. Since the long block case costs a lot of simulation time, some simulation results are included in the package. We also give the most classical introduction to the basic principles of EXIT charts from S. Ten Brink, as well as a document about analysis technologies for iterative decoding process in communication systems. Hope this will help.)

针对MIMO-OFDM系统中期望最大化(EM)信道估计算法在高信噪比(SNR)下带来的误差地板(EF)现象,且OFDM符号的数据传输效率随发射天线数的增加而明显降低,提出一种改进的高效EM信道估计算法。该算法首先引入一种准确的等效信号模型并推导出一种修正的EM算法,改善了EM算法在高SNR下的性能 在多个OFDM间利用相位正交导频序列来提高数据传输效率,同时进行联合信道估计以提高估计性能。仿真实验验证了所提算法具有更高的信道估计性能和更高的数据传输效率。(For multiple-input multiple-output with orthogonal frequency division multiplexing(MIMO-OFDM) systems,the error floor(EF) phenomenon at high signal noise rate(SNR) was induced by the expectation maximum(EM) channel estimation algorithm.In addition,the data transmission efficiency was declined obviously with the increasing number of transmit antennas.According to these problems,an improved and efficient EM channel estimation algorithm was pro-posed.Firstly,an accurate and equivalent signal model was introduc...)

说明：  dco-ofdm接收机仿真，在matlab上仿真dco-ofdm的ser/Eb/N0曲线(The simulation of dco-ofdm receiver and the ser/Eb/N0 curve of dco-ofdm on MATLAB)

modbus串口通讯动态链接库 使用同步通讯方式 (modbus serial communication dynamic link library using synchronous communication mode)