gridding.tar

內涵模糊理論與類神經網路的程式碼...提供初學者做研究參考(Connotation of fuzzy theory and neural network code ... to provide a reference for beginners to do research)

针对混沌参数调制( C P M) 的电力线通信( P L C) 中谐波引起的窄带干扰， 两阶段动态估计方法根据最小 相空间体积( MP S V) 准则估计模型参数， 计算量大。为此， 提出将未知参数合并到增广状态矩阵的联合卡尔曼滤 波方法， 避免了专门的参数估计过程， 在提高增益性能的同时有效降低了计算量。方法的性能通过对混沌电力 线通信下的单音干扰和多音干扰的有效抑制得到了验证。 (For the chaotic parameter modulation (CPM) of the power line communication (PLC) in the narrow-band interference caused by harmonics, two-phase dynamic estimation methods with minimum phase space volume (MP SV) criterion estimate model parameters, calculation of volume. Toward this end, the unknown parameters into augmented state matrix of the joint Kalman filter, to avoid the special parameter estimation process, while improving the performance gain reduces the amount of calculation. Method of performance under the power line communication by chaotic multitone jamming tone interference and the effective suppression has been verified.)

直接由声级计采集的瞬时声压级计算A声级及其1/3倍频程(Directly calculated with the instantaneous pressure level sound level meter to collect A levels and 1/3 octave)

线性及卷积混合信号盲源分离论文及算法 全是算法,看不懂也不要下了,慢慢看,免费的 (Linear and mixed-signal convolution papers and blind source separation algorithms are algorithms, do not know do not look down, and slowly watch, free)

说明：  阵列信号处理的基本doa算法，matlab下运行，非常有用(Array signal processing basic doa algorithm, matlab running, very useful)

图像阈值分割，为确定图像分割的最佳阈值，基于粒子群优化算法提出了一种多阈值图像分割方法(Image segmentation, image segmentation to determine the optimal threshold value, based on particle swarm optimization algorithm proposes a multi-threshold image segmentation)

vc与matcom混合编程实例，里面包含了matcom将matlab m文件转换成C++文件的例子，然后在vc中调用，画图，并借助matlab在vc中对音频文件进行幅度和相位分析(Vc mixed with matcom programming examples, containing the matcom transform matlab m file into the c++ file example, and then call in the vc, drawing, and with the help of matlab in the vc of amplitude and phase analysis was carried out on the audio file)

BROWNIAN_MOTION_SIMULATION

说明：  gsm的物理层仿真实现，仿真的目的不仅仅在于检查DSP程序实现的错误与否，还通过MATLAB制作相应的码表(gsm realize the physical layer simulation, the purpose of simulation is not merely to check the DSP program realize the error or not, through the production of the corresponding MATLAB code table)

使用Matlab/simulink实现运动可视化技术(Movement visualization based on Matlab/Simulink)