124666

stm32，通过spi总线实现对于TI的2543AD进行读写操作，串口uart输出数据(stm32, achieved through the spi bus for read and write to TI s 2543AD, serial uart output data)

1000以内所有的完数，比较简单，用于学习和交流(1000 all finished within few, relatively simple, for learning and communication)

说明：  一个基于kinect的鼠标小程序~~~用vs2008环境(A small program based on kinect mouse ~ ~ ~ with the vs2008 environment)

旋转LED的实现,实现用单片机控制电机转速，采用无线供电方式哦(Rotate the LED, achieving MCU control motor speed, the use of wireless power supply oh)

说明：  HLA仿真程序模板,使用的RTI为pRTI 1.3.(HLA templates, the use of the RTI pRTI 1.3.)

For this project you need a 3.7v power supply that prepared by LM317 regulator. So you need MAX232 for connect uart to pc .my AVR chip project is Mega8 that you can program on any Avr chip have 2kbyte rom. In bascom spi hardware don’t work correct, so I have to software spi ,but the software spi configure have low speed into hardware spi.

智能车接收上位机发送的指令，完成相应移动，包含三步，旋转、前进/后退、再旋转( U667A u80FD u8F66 u63A5 u6536 u4E0A u4F4D u673A u53D1 u9001 u7684 u6307 u4EE4 uFF0C u5B8C u6210 u76F8 u5E94 u79FB u52A8 uFF0C u5305 u542B u4E09 u6B65 uFF0C u65CB u8F6C u3001 u524D u8FDB / u540E u9000 u3001 u518D u65CB u8F6C)

智能追踪小车，并且可以用遥控手动控制转弯加前后左右(Intelligent tracking car, and can be controlled manually with the remote turn around Canada)

路虎开发板UC0S+UCGUI，LPC1768适用于路虎开发板(Land Rover development board UC0S+ UCGUI, LPC1768 development board for Land Rover)

三电平SVPWM仿真,运行很好，三电平SVPWM仿真,运行很好，分享给大家( Three level SVPWM simulation, the operation is very good)