APRBS

用MATLAB实现的BPSK,DELAY,OFDM,QPSK.仿真技术。来自MATLAB爱好者论坛。(Using MATLAB implementation BPSK, DELAY, OFDM, QPSK. Simulation technology. From the MATLAB lovers forum.)

通信中所用的一种递归RLS算法，用于建模(Communication used in a recursive RLS algorithm for modeling)

The model used for creating the reference voltage is shown in Fig. 4. First, photovoltaic output current (Ipv) and output voltage (Vpv) are passed through a first order low pass filter with a magnitude of G = 1 and a time constant of T = 0.01 seconds in order to filter out the high frequency components or harmonics from these signals as shown in Fig. 5 and Fig. 6. The filtered current and voltage signals (Ipv_F and Vpv_F) are then fed into the MPPT control block that uses the Incremental Conductance Tracking Algorithm. An algorithm that is based on the fact the slope of the PV array power curve shown in Fig. 7 is zero at the Maximum Power Point (MPP), positive on the left of the MPP, and negative on the right. The MPP can thus be tracked by comparing the instantaneous conductance (I/V) to the incremental conductance (∆ I/∆ V) [11] as in (1):

isodata聚类算法的matlab实现(isodata achieve clustering algorithm matlab)

有关乘积误差模型的估计 检验 最大似然估计值的获取 (MEM model estimation and test)

simulink中自己搭建的永磁同步电机模型，在相同参数下与系统自带的模型仿真对比，其输出波形完全一致，说明搭建的模型正确(Simulink u4E2D u81EA u5DF1 u642D u5ED u5ED u7EF0 u7EF0 u7R0 U81EA u5E26 u7A1 u6A1 u5782 u5R2 u5B09 u5B09 u0B09 U6A21 u578B u6B63 u786E)

Simulation modulation by matlab in computer

自己做的，发动机启动或断开控制模型，可以控制发动机的启停(Do it yourself, engine start or disconnect the control model, you can control the engine start and stop)

ANALYSIS OF D-FLIPFLOPS

说明：  用MATLAB编写的模拟退后程序，为通用模板，下载后修改即可使用。(Using MATLAB simulation back to prepare procedures for the generic template, modified to use after downloading.)