digital-display-clock

该程序是CRC校验程序，可以查看文件的校验和，这对文件本身进行校验，也可用在其它程序中检难数据正确与否(CRC procedures can view the document and check that the document itself calibration, but also can be used in other programs Frederick hard data are correct or not)

说明：  对c51单片机的0中断口的c语言初始化设置(0 c51 microcontroller interrupt port c language initialization settings)

基于51单片机的32和弦音乐盒程序，有曲目切换，音量调节，播放时间，步进电机驱动，流水灯等功能，是普通音乐的升级版本，且代码清晰，注释完整，结构合理。(Based on 51 single-chip 32 polyphonic music box procedures, switch tracks, adjust volume, play time, stepper motor drive, water lights and other functions, is an upgraded version of the ordinary music and clear code, comments, integrity, reasonable structure.)

基于正点原子stm32的频谱 a1读取ad信号显示(Punctuality atomic spectrum based stm32 a1 read signal display ad)

Pcomm开发的串口调试助手,能实现简单的发送和接收.(Pcomm development of serial debugging assistant)

自动交通控制系统用红、绿、黄三支共两组发光二极管表示交通信号灯，利用单片机模拟有时间显示的定时交通信号灯控制管理。信号灯的变化规律可如下： 1）放行线：绿灯亮放行25秒，黄灯亮警告5秒，然后红灯亮禁止。 2）禁示线：红灯亮禁止30秒，然后绿灯亮放行。 3）当某一方向的红灯亮时，若该方向有车通过，则用扬声器声报警。（撞红灯信号可用3-5V模拟量表示）(Automatic traffic control system using red, green, yellow light-emitting diodes, said a total of three traffic lights, the use of single-chip analog time display on a regular traffic signal control and management. Changes of lights to be as follows: 1) Release Line: green clearance 25 seconds, the yellow light warning for 5 seconds, then the red light is prohibited. 2) ban shows lines: the red light is prohibited for 30 seconds, then the green light to release. 3) When the red light in one direction, if the direction of the car through, the alarm speaker sound. (Hit the red signal available 3-5V analog representation))

MSP430F5529驱动DHT11,并用带字库的JLX12864显示(MSP430F5529 driver DHT11, and use the font JLX12864 display)

好的声文同步程序，值得学习，适合于初学者，给大家共同分享(Good sound text synchronization process, it is worth learning, suitable for beginners, for everyone to share)

cd4052用stm32来写的程序，，实现电子开关电路 (CD4052 uses STM32 to write the program, the electronic switch circuit)

在stc51单片机上，timer0、timer1、timer2的控制(In the stc51 microcontroller, timer0, Timer1, timer2 control)