juzhenjianpan

这是基于飞思卡尔十六位单片机的RS485通信的例程(freescale RS485 routine)

这是单片机的安装源程序，这是第一次上传的单片机资料，希望能对大家有用(This is a single chip installation source, this is the first single chip data upload, hope it' ll be useful)

基于低功耗单片机msp430f5438a的spiflash w25q128驱动 读写擦除(Based on low-power microcontroller msp430f5438a of spiflash w25q128 drive to read and write erase)

说明：  单片机c语言 初学者有用 有例子哦 (SCM c language for beginners there are examples of useful oh)

通过单片机实现哈希函数SHA-1，C源程序完全可用，已经测试，外部加密芯片采用DS28E01-100(MCU hash function SHA-1, C source code fully available, and has been tested external encryption chip uses DS28E01-100)

说明：  用单片机实现的DS1621温度传感器，测量周边环境的温度(With MCU' s DS1621 temperature sensor to measure the temperature of the surrounding environment)

ad转换的程序，c8051f021老程序，18B20测温00，抢答器程序，pwm_pac.c。(ad conversion process, c8051f021 old procedures, 18B20 temperature 00, Answer program, pwm_pac.c.)

步进电机28BYJ48型四相八拍电机，电压为DC5V—DC12V。当对步进电机施加一系列连续不断的控制脉冲时，它可以连续不断地转动。每一个脉冲信号对应步进电机的某一相或两相绕组的通电状态改变一次，也就对应转子转过一定的角度（一个步距角）。当通电状态的改变完成一个循环时，转子转过一个齿距。四相步进电机可以在不同的通电方式下运行，常见的通电方式有单（单相绕组通电）四拍（A-B-C-D-A。。。），双（双相绕组通电）四拍（AB-BC-CD-DA-AB-。。。），八拍（A-AB-B-BC-C-CD-D-DA-A。。。）(Stepping Motor 28BYJ48 four-phase eight-phase motor, the voltage DC5V-DC12V. When a series of continuous control pulses are applied to the stepper motor, it can be continuously rotated. Each pulse signal corresponds to the stepper motor of a phase or two-phase winding power state change once, also corresponds to the rotor through a certain angle (a step angle). When the change in the power-on state completes one cycle, the rotor turns one pitch. Four-phase stepper motors can be operated in different power-up modes. The common power-up modes are: single-phase winding power (ABCDA ...), double (dual-phase winding)-DA-AB-...), eight beats (A-AB-B-BC-C-CD-)

此程序为4*4矩阵键盘，键盘自身不带电源电阻，八个接线，在程序中进行需进行软件拉高拉低以便按键扫描。 应用单片机为MSP430F5529。(4* 4 matrix keyboard without power resistors MSP430F5529)

RAID卡的测试程序，写的不好哈，请大家原谅，(RAID card test procedures and writing bad Kazakhstan,)