Test_colour_new

《无线通信系统仿真--C++实用模型》一书的配套源代码，里面包含了，通信系统的所有模块，对学习通信和C++有很好的借鉴()

用stm32单片机进行pwm输出和ADC设置(USE STM32 MCU OUT PUT PWM WAVE AND ADC)

DHT11的C51驱动程序，4位数码管可以显示温度和湿度，带一触发按键(DHT11 C51 driver, four digital tube can display temperature and humidity, with a trigger button)

此代码是关于利用51单片机实现步进，滞留等程序的参考用。(This code is on the use of 51 single-chip stepper, detention and other procedures for reference.)

MCU图片解码，使用STM32对JPEG图片解码，(STM32 JPEG decoder code,)

PROFIBUS调试助手ProfiAssistV2.40(PROFIBUS debugging assistant ProfiAssistV2.40)

模拟键盘击键,比较不错的一个程序.做软件仿真的(Analog keyboard keystrokes, compare a good one. To do software simulation of)

一台安捷伦的N9020A频谱分析仪，所带的例子是GPIB连接的，现在用LAN来连接。 (Agilent N9020A spectrum analyzer, the example brought to GPIB connection, use the LAN to connect.)

无差拍PFC仿真代码，在PSIM下的电路仿真(Deadbeat PFC simulation code, circuit simulation in PSIM)

使用方法： 程序设置了ENC28J60的IP为192.168.0.15，模块通电后与电脑的网口用网线连接起来， 设置电脑的本地IP为192.168.0.**（**自定），网关为192.168.0.15,其他默认，配置 成功后便可以arp或ping模块。 打开浏览器，在地址里输入http://192.168.0.15/123456可打开开发板简单网页，页 面上通过按键来控制开发板LED的亮灭。(Use: setup the ENC28J60 of IP to 192.168.0.15, the module is powered on the computer' s Ethernet port using a cable connection up to set the computer' s local IP 192.168.0.** (** Custom), the gateway 192.168.0.15, default configuration is successful, it will make arp or ping module. Open the browser, enter the address http://192.168.0.15/123456 to open the development board simple web pages, and page keys to control the development board LED light off.)