Upcf8583s

stm8系列单片机，控制八位数码管按键计数(stm8 series microcontrollers, digital control buttons eight counts)

51单片机控制NAND Flash读写程序,编译环境vc++，可根据flash不同做稍加修改,即可实现功能要求(51 single-chip NAND Flash read and write procedures, compile environmental vc++, according to flash a little modified)

基于keil 51的LCD12864驱动开发程序，工程文件已建好，可以直接使用(Based keil 51 of LCD12864 driver development program, project files have been built, can be used directly)

有限差分波动方程不加边界条件二阶正演时间切片程序。(Finite difference wave equation without boundary conditions of second-order forward time-slicing procedure.)

这是一个为数不多的用C语言编写的PIC12C508的RGB灯的小型控制器，交流同步信号检测，七彩跳变+七彩渐变，做LED的朋友可以参考，程序可以直接使用的；(This is a small controller RGB lights a few written by C PIC12C508, AC synchronous signal detection, colorful jump+ colorful gradient, do LED friends can reference, the program can be used directly )

单片机音频通信9170和9200，接收发送源程序(9170 and 9200 microcontroller audio communication, the receiver sends source)

6自由度机械臂从臂的控制程序，实现主从臂遥操作控制。(6 DOF manipulator arm the control program, using the integrated cards.)

智能车开发串口接收数据上位机软件.源代码.如果自己加上数据分析功能,就非常有用.(Development of intelligent vehicle PC software serial receive data. The source code. If they combined data analysis, it is very useful.)

这段代码包括了基于STM32对简单小车的循迹壁障以及L298N的驱动。并对其中关键部分进行了注释。(This code includes a simple car-based STM32 tracking barrier and L298N driver. And one of the key parts of the notes.)

说明：  两个12V的电机驱动履带式底盘完成到制定目标运动的任务，可以通过点触屏进行无线控制。(Two 12V motor-driven crawler chassis complete the task of setting the target motion, which can be controlled by wireless touch screen.)