Source

matlab程序　数字信号处理 用于采样信号(Matlab digital signal processing procedures for the sampling signal)

MATLAB Code for Parametric Method of Spectrum estimatin. using Auto Regressive Method, Both levinson Durbin recursion and yule waker method,

The sourcecode of Universally-Convergent Squared-Operator Iteration Methods for fig2 using SOM

说明：  升压转换器是一种DC / DC电源转换器，可将电压从其输入（源）升至其输出（负载）。在连续导通模式下（流经电感的电流永远不会降为零），升压转换器的理论传递函数为： 占空比在哪里0.5 在此示例中，转换器从250 V电源馈送RC负载，并且PWM频率设置为31 kHz。 模拟 运行仿真并观察示波器上的波形。确认负载电压（Vout）的平均值非常接近理论值：Vout = 250 /（1- 0.5）= 500V。(A boost converter is a DC/DC power converter which steps up voltage from its input (source) to its output (load). In continuous conduction mode (current through the inductor never falls to zero), the theoretical transfer function of the boost converter is: where is the duty cycle.0.5 In this example, the converter is feeding an RC load from a 250 V source and the PWM frequency is set to 31 kHz. Simulation Run the simulation and observe waveforms on Scope. Verify that the mean value of the load voltage (Vout) is very close to the theoretical value of: Vout = 250 / (1 - 0.5) = 500 V.)

函数插值，Hermit和在不同边界条件下的样条插值以及效果图(Function interpolation, Hermit, and the different boundary conditions and the results of spline interpolation map)

图像配准中的两幅图像的归一化互信息计算方法代码(Image registration of two images of the normalized mutual information method code)

运用矩量法计算空心圆筒的电参数，源代码清晰详细，适于学习，附有图片(Calculated using the method of moments electrical parameters of the hollow cylinder, source code, clear and detailed, for learning, with pictures)

QPSK程序代码 非常有用的东西 尽管不是本人原创，但比较都经典。文件为*.m格式(QPSK code very useful, although not my original thing, but the classic comparison. Document format*. m)

MATLAB鲁棒控制工具箱，详细介绍工具箱的应用及实例讲解。(MATLAB Robust Control Toolbox, detailing the toolbox applications and examples to explain.)

用matlab分析传统光学系统中加入三次相位掩模板之后所获得的光线像差(Analysis using matlab conventional optical system by adding three phase mask obtained after the aberration of light)