maxminest

Patterns of Enterprise application architecture

Computes motion vectors using Adaptive Rood Pattern Search method Based on the paper by Yao Nie

用FFT计算信号的功率谱密度时，需要先计算FFT，再计算双边谱密度，然后计算单边谱密度。在matlab里注意FFt要除以采样点数，计算双边谱时要注意除以频率分辨率。 ( When calculated using the FFT power spectrum density signal, you need to calculate the FFT, and then calculate the bilateral spectral density, and then calculate the unilateral spectral density. In matlab in Note FFt divided by sampling points should be noted when calculating the bilateral spectrum divided by the frequency resolution.)

能够对数据进行降噪处理，能有效的降噪，提出故障特征~(failed to translate)

RLC matlab simulink arrangment

this program will make skew correction of character

LASSO 算法，lars算法,有些例程(LASSO LARS examples)

风力发电最大功率点跟踪，采用爬山法，matlAB自带永磁同步电机，buck电路降压(Wind power maximum power point tracking, using climbing method, matlAB own permanent magnet synchronous motor, buck buck circuit)

DC-DC 转换的Simulink 模型with PWM PI control(DC-DC conversion of the Simulink model with PWM PI control)

通过PCCARD SPEC测试笔记本的外部接口的电压是正常(through PCCARD SPEC test notebook external interface voltage is normal)