Doa

matlab windup的应用文件说明,(matlab windup)

nc mfsk调制，包括了bfsk,qfsk,8fsk等东西(nc mfsk modulation, including bfsk, qfsk, 8fsk and other things)

可以用来求ADC的SNDR的m文件，需要ADC的输出作为txt文件输入(M files for SNDR that can be used for ADC)

1.分别在两个图中画出δ(n)和δ(n-2)，其中-10≤n≤10，画出U（n）其中-10≤n≤10。 2.分别在两个图中画出x1(n)=cos(2π×20×0.01×n)，0≤n≤10和x2(n)=(0.8)n，1≤n≤6。 3.由上一题，计算y(n)=x1(n)+x2(n)，并画图。(1. Draw the figure at two δ (n) and δ (n-2), where-10 ≤ n ≤ 10, draw the U (n) where-10 ≤ n ≤ 10. 2. Respectively in the two Draw the figure x1 (n) = cos (2π × 20 × 0.01 × n), 0 ≤ n ≤ 10 and x2 (n) = (0.8) n, 1 ≤ n ≤ 6. 3. from the previous question, calculate y (n) = x1 (n)+ x2 (n), and drawing.)

一个很好用的遗传算法标准程序,很时候初学者使用和应用研究.(a good use of the genetic algorithm standard procedure, very often beginners and applied research.)

基于粒子群优化与灰色系统理论的多目标优化程序，很好用(Based on Particle Swarm Optimization and gray system theory of multi-objective optimization process, a very good use)

将遗传算法应用于一元函数的优化，程序运行通过！(a GA)

this is computer communication network book

说明：  关于VC++与Matlab混合编程的一些参考文献，很有参考价值(On VC++ and Matlab programming mix some reference, a good reference)

本人亲手做的一个matlab扩频通信系统simulink仿真系统。从发送端到接收到，每部分都相应得加了示波器或频谱仪，可以对照理论清楚观察到信号发生的变化。matlab6.5及以上版本上运行。(I personally make a matlab Spread Spectrum Communication System simulink simulation system. Send-ended to receive from every part of a corresponding increase in the oscilloscope or spectrum analyzer can be clearly observed in the control theory of signal changes. matlab6.5 and above to run.)