登录
首页 » Visual Basic » Boiler-heat-balance-calculations

Boiler-heat-balance-calculations

于 2013-07-15 发布 文件大小:263KB
0 353
下载积分: 1 下载次数: 7

代码说明:

  锅炉热平衡计算是指输入锅炉机组的热量和锅炉机组输出热量之间的平衡(Boiler heat balance calculation refers to the input heat boiler unit and boiler unit balance between the heat output)

下载说明:请别用迅雷下载,失败请重下,重下不扣分!

发表评论

0 个回复

  • SMV-GOOSE-SNTP-Test-Tools
    模拟发送GOOSE SV SNTP等,是智能变电站应用开发的实用工具,详细的说明在压缩包里边,压缩包里包含三个压缩包,分别是集成测试工具、协议安装包、协议安装说明等。(Analog transmission GOOSE SV SNTP, are intelligent application development utility substation, detailed instructions inside the archive, compressed package includes three compressed, respectively, integrated test tools, protocol package, installation instructions and other agreements)
    2020-09-10 15:28:01下载
    积分:1
  • power-flow
    说明:  c语言,电力系统潮流计算程序,通用,工程开发应用使用(power flow calculator)
    2011-03-24 18:21:05下载
    积分:1
  • Boiler-heat-balance-calculations
    锅炉热平衡计算是指输入锅炉机组的热量和锅炉机组输出热量之间的平衡(Boiler heat balance calculation refers to the input heat boiler unit and boiler unit balance between the heat output)
    2013-07-15 17:42:50下载
    积分:1
  • IEEE39
    atp是电力系统暂态仿真软件,在atp仿真软件上建立了IEEE三机九节点的仿真模型,并得到了潮流及稳定的仿真结果(atp is the power system transient simulation software, simulation software in the atp built on the IEEE three-machine nine nodes in the simulation model, and has been the trend and stability of simulation results)
    2011-10-05 09:35:23下载
    积分:1
  • Newton-Raphson-power-flow
    电力系统稳态分析-课程作业-用牛顿拉夫逊法求解潮流-C++下编译通过,注释清晰,思路清楚,值得参考。(Steady power system analysis- coursework- Newton Raphson method to solve the current-C++ compiler, comments clear, clear thinking, good reference.)
    2015-05-26 15:33:57下载
    积分:1
  • 机组组合问题wind_new
    程序自定义输入输出,解决电力系统机组组合问题。(Program custom input and output, to solve the problem of power system unit combination.)
    2017-09-13 09:48:37下载
    积分:1
  • machine
    本程序为基于多回路理论的单相异步电机故障诊断程序,具有良好的效果(This program is based on multi-loop theory for single phase induction motor fault diagnosis procedures, with good results)
    2020-11-26 10:39:31下载
    积分:1
  • Experiment-3
    计算离散信号的振幅谱和相位谱 1. 编写计算DFT的程序。 2. 编写计算振幅谱和相位谱的程序。 (DSP)
    2009-05-21 23:43:29下载
    积分:1
  • Load-Calculation
    《电力系统稳态分析》第三版,中国电力出版社,书上P95页,例3-4。经过计算机C语言编程,运用牛顿拉夫逊法,把简单的电力系统潮流进行计算。(load calculation)
    2012-03-22 17:22:47下载
    积分:1
  • DppX123MinMFC
    说明:  美国ATMP公司,X光谱分析仪硬件数据采集精简版部分MFC包装程序,本程序采用VS2008编译通过。 (U.S. ATMP company, X spectrometer data acquisition hardware part of MFC wrapper Starter Edition, the program uses VS2008 compile.)
    2011-02-28 09:37:00下载
    积分:1
  • 696516资源总数
  • 106914会员总数
  • 0今日下载