SMV-GOOSE-SNTP-Test-Tools

蒸发冷凝的udf，，包括传热传质，对应于水(Evaporative condensation of UDF, including heat and mass transfer, corresponds to water)

第一类高阻抗含气砂岩AVO正演（自激自收）(The first class of high-impedance gas sands AVO forward)

说明：  IEEE5节点经典算例程序，非常完整的潮流计算程序，对电力系统自动化专业的学生非常有用 (IEEE5classic example node procedure is a complete flow calculation procedure of the power system is very useful for students Automation)

atp是电力系统暂态仿真软件，在atp仿真软件上建立了IEEE三机九节点的仿真模型，并得到了潮流及稳定的仿真结果(atp is the power system transient simulation software, simulation software in the atp built on the IEEE three-machine nine nodes in the simulation model, and has been the trend and stability of simulation results)

电力系统稳态分析-课程作业-用牛顿拉夫逊法求解潮流-C++下编译通过，注释清晰，思路清楚，值得参考。(Steady power system analysis- coursework- Newton Raphson method to solve the current-C++ compiler, comments clear, clear thinking, good reference.)

采用MD5加密的采制化三级编码管理系统，对燃煤电厂入厂煤采制化进行管理。(Use md5 encryption for heat-engine English level 3 coding management system)

本程序为基于多回路理论的单相异步电机故障诊断程序，具有良好的效果(This program is based on multi-loop theory for single phase induction motor fault diagnosis procedures, with good results)

求取两个信号的到褶积，通常在用地震方法找油气中用雷克子波和反射系数求取褶积，本程序只是搭建了一个大致的框架，如果需要的到结果，还需要自行设置信号和一些参数。(Strike to the convolution of two signals, typically using seismic methods used to find oil and gas Ricker strike wave and reflection coefficient convolution, this procedure is to build a general framework, if the desired results, you need to set your own signal and some parameters)

beggs will计算的vb应用，用于计算两相流动态压降(beggs will calculattion)

8MPa 下 CO2/H2O质量比96 /4 的物性参数 适用于东芝超临界二氧化碳循环工质(8MPa under the CO2/H2O mass ratio of 96 /4 of the physical parameters for Toshiba supercritical carbon dioxide circulating fluid)