Large-wind-farms-stability

求取两个信号的到褶积，通常在用地震方法找油气中用雷克子波和反射系数求取褶积，本程序只是搭建了一个大致的框架，如果需要的到结果，还需要自行设置信号和一些参数。(Strike to the convolution of two signals, typically using seismic methods used to find oil and gas Ricker strike wave and reflection coefficient convolution, this procedure is to build a general framework, if the desired results, you need to set your own signal and some parameters)

计算离散信号的振幅谱和相位谱 1. 编写计算DFT的程序。 2. 编写计算振幅谱和相位谱的程序。 (DSP)

说明：  c语言，电力系统潮流计算程序，通用，工程开发应用使用(power flow calculator)

采用MD5加密的采制化三级编码管理系统，对燃煤电厂入厂煤采制化进行管理。(Use md5 encryption for heat-engine English level 3 coding management system)

IEC101-104 电力规约通讯实现及测试软件，VC2003下编译运行通过。支持串口以太网(IEC101-104 power protocol communication and testing software, VC2003 compiler run through. Support serial port Ethernet)

锅炉热平衡计算是指输入锅炉机组的热量和锅炉机组输出热量之间的平衡(Boiler heat balance calculation refers to the input heat boiler unit and boiler unit balance between the heat output)

一个变电站系统的运行模拟程序，基于vc。(A substation operation of the system simulation program , based on the vc)

ASN.1 编码规则：分组编码规则,各种数据类型的ASN.1的编码方式,非常有用,值得一看(ITU-T Recommendation X.690 (2002) | ISO/IEC 8825-1:2002, Information technology –ASN.1 encoding rules:Specification of Packed Encoding Rules (PER))

8MPa 下 CO2/H2O质量比96 /4 的物性参数 适用于东芝超临界二氧化碳循环工质(8MPa under the CO2/H2O mass ratio of 96 /4 of the physical parameters for Toshiba supercritical carbon dioxide circulating fluid)

该程序计算翅片式冷凝器选型软件，制冷剂为R22,根据冷媒侧进出口参数求换热面积。比较实用的(The program calculates fin type condenser selection software, refrigerant R22, according to refrigerant side inlet and outlet parameters for heat exchange area. More practical)