IEEE39

程序自定义输入输出，解决电力系统机组组合问题。(Program custom input and output, to solve the problem of power system unit combination.)

锅炉热平衡计算是指输入锅炉机组的热量和锅炉机组输出热量之间的平衡(Boiler heat balance calculation refers to the input heat boiler unit and boiler unit balance between the heat output)

电力系统稳态分析-课程作业-用牛顿拉夫逊法求解潮流-C++下编译通过，注释清晰，思路清楚，值得参考。(Steady power system analysis- coursework- Newton Raphson method to solve the current-C++ compiler, comments clear, clear thinking, good reference.)

蒸发冷凝的udf，，包括传热传质，对应于水(Evaporative condensation of UDF, including heat and mass transfer, corresponds to water)

说明：  IEEE5节点经典算例程序，非常完整的潮流计算程序，对电力系统自动化专业的学生非常有用 (IEEE5classic example node procedure is a complete flow calculation procedure of the power system is very useful for students Automation)

atp是电力系统暂态仿真软件，在atp仿真软件上建立了IEEE三机九节点的仿真模型，并得到了潮流及稳定的仿真结果(atp is the power system transient simulation software, simulation software in the atp built on the IEEE three-machine nine nodes in the simulation model, and has been the trend and stability of simulation results)

自己编的测井数据处理软件，用于处理测井数据，有例子(Own series of logging data processing software for processing log data, there are examples)

最小平方反褶积的相关程序，可用于相关地震资料的处理和分析(Least squares deconvolution procedures, can be used for correlation of seismic data processing and analysis)

大型风电场接入电网的稳定性问题研究,希望对大家有点启发( the problems of Large wind farms connected to the grid stability)

求取两个信号的到褶积，通常在用地震方法找油气中用雷克子波和反射系数求取褶积，本程序只是搭建了一个大致的框架，如果需要的到结果，还需要自行设置信号和一些参数。(Strike to the convolution of two signals, typically using seismic methods used to find oil and gas Ricker strike wave and reflection coefficient convolution, this procedure is to build a general framework, if the desired results, you need to set your own signal and some parameters)