vb-example

说明：  PIC单片机红外线遥控接收解码实例 //芯片配置字，看门狗关，上电延时开，掉电检测关，低压编程关，加密，4M晶体HS振荡(PIC Microcontroller Infrared Remote Control Receiver Decoder instance of// chip configuration word, watchdog off, power-on delay to open, brown-out detection pass, low-voltage programming off, encryption, 4M crystal oscillator HS)

这段代码包括了基于STM32对简单小车的循迹壁障以及L298N的驱动。并对其中关键部分进行了注释。(This code includes a simple car-based STM32 tracking barrier and L298N driver. And one of the key parts of the notes.)

实现坐标的显示 随机数产生 并显示到listctrl中 声称坐标轴 显示随机数，排序( Achieve coordinate display random number is generated and displayed to listctrl claimed axis shows random numbers, sorting)

说明：  一个特别好的modbus从机扫描程序，可以以RTU或ASCII方式通信以此来检验下位机。(A particularly good modbus slave scanner can communicate with RTU or ASCII way to test this lower position.)

超再生遥控-遥控步进电机正反转AB的程序(Superregeneration Remote- remote control stepper motor program AB)

msp430 149各个模块编程，时钟，电源，flash，uart，等等(each module programming msp430 149)

iCan4017模块改进程序，语言Windows Visual C++(iCan4017 programme, Windows Visual C++.)

利用Arduino实现读取MPU6050的DMP四元数(Arduino MCU reads MPU6050 use a DMP quaternion)

AVR单片机 定时器的应用 初始化 以及中断程序(AVR microcontroller timer application initialization and interrupt routine)

STC12C5204AD单片机控制单个二极管闪烁源代码，二极管由138译码器使能，另一端单片机IO口控制，采用延时程序，是单片机初学者很好的学习源代码(STC12C5204AD flash microcontroller source code to control a single diode, diode 138 by the decoding is enabled, the other end of the single-chip IO port control, using the delay procedure is a very good chip for beginners to learn the source code)