mfcc

光纤Bragg光栅的基模（LP01）的测试程序，欢迎拍砖

这是基于约束最大期望算法的matlab程序，对参数估计及图像分割有较大作用(This is based on expectations of the biggest constraint algorithm Matlab procedures, parameter estimation and image segmentation greater role)

The plots of the Poynting vector might serve to show which part of the wire is mainly responsible for creating the radiated field. The movie of the modulus, |S|, does not give a clear answer, since at close distances the pointing vector reaches high values along the entire wire. The fact that |S| is high along the entire line just means that energy is shifted between the endpoints and the middle region (electric and magnetic field respectively).

this is can apply to run simulink

数据矩阵运用非负矩阵分解算法，分解得到两个低维矩阵，并用于信号分离。(The data matrix is decomposed into two low-dimensional matrices by non-negative matrix decomposition algorithm and used for signal separation.)

这是一个横侧姿态保持系统的sinmulink仿真框图(This is a horizontal side to keep the system sinmulink simulation profile diagram)

Gabor Filter Construction

无刷直流电机Matlab/Simulink仿真(BLDC Simulink simulation)

说明：   图像分割迭代、峰谷、半阈值算法。(Image segmentation iterative, peak, semi-threshold algorithm.)

The demand of high data rate services has been increasing very rapidly and there is no slowdown in sight. We know that the data transmission includes both wired and wireless medium. Often, these services require very reliable data transmission over very harsh environment. Most of these transmission systems experience much degradation such as large attenuation, noise, multipath, interference, time variance, nonlinearities and must meet the finite constraints like power limitation and cost factor. One physical layer technique that has gained a lot of popularities due to its robustness in dealing with these impairments is multi-carrier modulation technique. In multi-carrier modulation, the most commonly used technique is Orthogonal Frequency Division Multiplexing (OFDM)