routh

xwch_test.m是主测试文件；biaoji.mat存放滤波器系数；xiangweicha.m用FFT计算相位差。 仿真框架为： 1.标记信号和双音信号续接作为发送信号； 2.对双音中一个频率分量的相位做偏移，再经过一个低通滤波器（引入线性相位，模拟收发不能同步测量现象）后，作为收到的信号； 3.用一个检测信号对收发信号进行相关运算； 4.画出收发信号以及相关处理后的信号。找出相关信号的那个尖点，从而推算出收发双音信号0相位点； 5. 输入0相位点位置，计算相对相位差。(xwch_test.m is the main test file biaoji.mat store filter coefficients xiangweicha.m calculated using FFT phase difference. Simulation framework: 1. Mark signals and then as a two-tone signal continued to send signals 2. On a two-tone frequency components of the phase shift to do, and then through a low pass filter (the introduction of linear phase, simulation can not simultaneously send and receive measuring the phenomenon), the as received signal 3. using a detection signal of the transceiver signal correlation operation 4. draw send and receive signals and related processed signal. Correlated signal of the cusp, which calculate the two-tone signal transceiver 0 phase point 5. Enter 0 phase point position, calculate the relative phase difference.)

《无线通信FPGA设计》一书中例子的Matlab及verilog代码(" Wireless FPGA Design" a book example of Matlab and the verilog code)

matlab实现牛顿插值，一个简单的程序(matlab implementation of Newton interpolation, a simple procedure)

说明：  精通matlab综合辅导与指南，详细介绍了Matlab的操作与编程。(proficient Matlab comprehensive counseling and guidance, details of the operation and Matlab programming.)

宽带时延波束形成仿真程序，通俗易懂，适于初学(broadband beamforming simulation procedures, user-friendly and suitable for beginners)

共轭梯度法最优化算法matlab源程序。。(Conjugate Gradient Method optimization algorithm matlab source code. .)

说明：  MATLAB的使用说明书、参考手册，以及一些例程的说明和实现(The use of MATLAB instructions, reference manuals, as well as some routine specification and implementation)

这个代码是用来实现特征滤波器的，该滤波器基于最小二乘法，可以实现低通高通带通带阻带通等功能。(This program is to realize an Eigenfilter,which is based on total least squares.)

联合开发网 - pudn.com

学自控的人应该好好看看哦！直接用其强大的函数功能。(good!)