AnimalBoy

造纸自动化生产线的s7300程序，点数之多，很是复杂，值得大家一读！(paper automated production lines in the s7300 procedures, many points, very complicated and worth a read!)

说明：  金沙滩（KingST）C51单片机的开发板原理图(Principle diagram of C51 development board in Jinshatan)

美国达拉斯温度传感器DS18B20的温度数值转化程序。(Dallas DS18B20 the temperature into numerical procedures.)

RC522的51例程，包括电路图等，非常适合初学者。(51 of RC522 routines, including circuit diagrams, very suitable for beginners.)

包含proteus仿真文件及c语言程序，在开发板上进行过运行。利用双色LED显示电路，和四位静态数码管显示电路模拟十字路口交通信号灯。4位LED数码管显示时间，双色LED灯显示红绿灯状态。熟悉交通信号灯控制逻辑。设计一个十字路口的交通灯控制电路，要求南北方向和东西方向两个交叉路口的车辆交替运行。每次绿灯变红灯时,要求黄灯先亮3S,才能变换运行车辆。东西方向、南北方向车道除了有红、黄、绿灯指示外，每一种灯亮的时间都用数码管显示器进行显示（采用倒计时的方法）。考虑到特殊车辆情况，设置紧急转换开头。(It contains proteus simulation file and C language program. It has been run on the development board. Two-color LED display circuit and four-bit static digital tube display circuit are used to simulate traffic lights at intersections. Four-bit LED digital tube display time, two-color LED lights show the status of traffic lights. Familiar with traffic signal control logic. Design a traffic light control circuit at the intersection, which requires the vehicles running alternately in the north-south direction and the East-West direction. Every time the green light turns red, the yellow light is required to turn on 3S before changing the running vehicle. In addition to the red, yellow and green lights in the east-west and North-South lanes, the time of each kind of light is displayed by digital tube display (countdown method). Considering the special vehicle situation, set up the emergency switch start.)

主要是完成Listctr的封装,和对于xlistctrl 的一个实例程序 (The main package is completed Listctr)

C8051F360 主频工作在76M的频率下，设置缓存FiFo进行数据采集，控制TLC5540(C8051F360 frequency of work at the frequency of 76M, set the cache FiFo for data acquisition, control TLC5540)

10M网线与100M网线和1000M(千兆)网线做法! (10M of cable and the 100M network cable and 1000M (gigabit) cable practice!)

基于单片机的电子密码锁，采用c语言编写，可以用的(Microcontroller-based electronic locks, using c language, can be used)

stm32f107can收发程序，波特率为500k，回环模式正常模式均可以正常工作，波特率可以自己修改，发送数据长度，id都可以修改。(stm32f107can transceiver procedures, the baud rate is 500k, loopback mode Normal mode can work, you can make changes to the baud rate, transmission data length, id can be modified.)