bilinear_toolbox_v01

华中科技大学现代控制理论Matlab问题华中科技大学现代控制理论 Matlab问题(Modern Control Theory, Huazhong University of Science and Technology, Huazhong University of Science Matlab problem Matlab problems of modern control theory)

PCA主成分分析算法的matlab实现，经过测试可以运行(PCA method in matlab)

texture analysis using ANN

pwm整流器的MATLAB仿真程序，都正确。(MATLAB PWM conventer)

简单的求解tsp问题，比matlab demo中的更细，用的是蚂蚁算法。(Tsp solving simple problems, matlab demo than in the more detailed, using the ant algorithm.)

《最优化方法及其Matlab程序设计》较系统地介绍了非线性最优化问题的基本理论和算法，以及主要算法的Matlab程序设计，主要内容包括（精确或非精确）线搜索技术、最速下降法与（修正）牛顿法、共轭梯度法、拟牛顿法、信赖域方法、非线性最小二乘问题的解法、约束优化问题的最优性条件、罚函数法、可行方向法、二次规划问题的解法、序列二次规划法等。(" Optimization Methods and Matlab programming" more systematic introduction to the basic theory and algorithms nonlinear optimization problem and the main algorithm Matlab programming, the main contents include (exact or non-exact) line search technique, the steepest descent method and (corrected) Newton method, conjugate gradient method, quasi-Newton method, trust region methods, solution of nonlinear least squares problems, constrained optimization problem optimality conditions, penalty function method, feasible direction method, quadratic programming problems The solution, the sequential quadratic programming method.)

基于灰度匹配准则的图像匹配，能快速找出对应下帧图像中对应的图像(Matching criterion based on a grayscale image matching, can quickly find out the corresponding frame image in the image )

Orthogonal Frequency Division Multiplexing bit error rate Measurement.

说明：  generate white noise

Mysmo.mdl 永磁同步电机的主程序，可以实现有速度传感器启动运行，和无速度传感器运行。 SMOmodel.m 改进的滑模观测器模型，实现永磁同步电机反电动势的估算。 PFCDCM0hm5 用的是0.5hm的电感，实现220V交流电变换成400V的直流电，电流断续。 由于是仿真，如果要硬件实现的话，除了需要电压采样外，还需要一个输入电压过零检测 PFCCM320percent98k50 用的是5hm的电感，实现220V交流电变换成320V的直流电，电流连续。功率因数可以达到0.98，用的开关频率为50K PFCCM400percent97k50.mdl 用的是5hm的电感，实现220V交流电变换成400V的直流电，电流连续。功率因数可以达到0.97，用的开关频率为50K (Permanent magnet synchronous motor Mysmo.mdl main program, you can achieve the speed sensor up and running, and speed sensors run. SMOmodel.m improved sliding mode observer model permanent magnet synchronous motor back-EMF estimates. PFCDCM0hm5 with is 0.5hm inductor to achieve 220V AC transform into a 400V DC current is interrupted. As the simulation, hardware implementation, then, in addition to the voltage sampling an input voltage over zero detection PFCCM320percent98k50 the is 5hm inductance to achieve transformation 220V AC 320V DC continuous current. The power factor can reach 0.98, the switching frequency for 50K PFCCM400percent97k50.mdl with is 5hm inductance 220V AC transform 400V DC continuous current. The power factor can reach 0.97, with the switching frequency is 50K)