Method1

LMS&RLS自适应算法 另有代码说明文档(adaptive algorithm：including LMS&RLS An introduction document is provided!)

通过Matlab，实现Gabor与SVM的结合，实现对大样本数据的车辆与非车辆的模式识别，样本可以自己准备，由于过大没有上传(By Matlab, the combination of Gabor and SVM, vehicles and vehicles of large sample data pattern recognition)

粒子束算法 matlab 站长把时间都花(pos matlab calculator 容说明(至少要20个字)。尽量不要让站长把时间都花费在为您修正说)

给出接收信号眼图及系统仿真误码率，快速扩展随机生成树算法，有PMUSIC 校正前和校正后的比较。( The received signal is given eye and BER simulation systems, Rapid expansion of random spanning tree algorithm, A relatively before correction and after correction PMUSIC.)

子载波数 128 位数/ 符号 2 符号数/ 载波 1000 训练符号数 0 循环前缀长度 8 (1/16)*T 调制方式 4-QAM 多径信道数 3 IFFT Size 128 信道最大时延 2 (Subcarriers median number of 128 percent/2 percent symbol symbol number/carrier training symbols 1000 a few 0 cyclic prefix length of 8 (1/16)* T modulation 4-QAM the number of multi-path channel 3 IFFT Size 128 the largest delay channel 2)

QPSK信号经过调制，高斯信道，带通滤波器，解调，判决，误码率仿真( QPSK modulated signal, Gaussian channel, bandpass filters, demodulation, judgments, BER simulation)

产生随机数的方法很多，很多软件自己就有产生随机数函数，本程序用的是乘同余法产生随机数，经对比，效果比matlab自带的要好。(Many methods of generating random Numbers, this procedure is by using congruence method generating random Numbers.)

设计一个数字滤波器，在频率低于 的范围内，低通幅度特性为常数，并且不低于0.75dB。在频率 和 之间，阻带衰减至少为20dB。 (1)试求满足这些条件的最低阶Butterworth滤波器。(Design a digital filter, in the range of frequencies below the low-pass amplitude characteristic is constant, and not less than 0.75dB. Between the frequency and stop-band attenuation of at least 20dB. (1) Determine the lowest-order Butterworth filter to meet these conditions.)

子阵列划分的root-music algorithm(Sub-array by root-music algorithm)

直序扩频通信系统仿真实例 程序代码 simulingk仿真(Direct Sequence Spread Spectrum Communication System Simulation simulation code simulingk)