NeuralNetwork

基于贝叶斯学习的算法，对一系列信号进行聚类分析(Bayesian learning algorithm based on cluster analysis of a series of signals)

静止点目标的距离-多谱勒（R-D）成像算法,有徙动校正模块，根据保铮老师的《雷达成像技术》一书编写，对雷达成像的初学者帮助很大！！(Stationary point target range- Doppler (RD) imaging algorithm, there is migration correction module, according to Bao Zheng teacher radar imaging--a book written for beginners on the radar imaging is very helpful! !)

为了最大限度地减少能源采集充电通信系统传输完成时间，各 传输调度方案已被提出。然而，他们并没有考虑这个问题，其中一个发射器可能会失败 之前完成传输。为广播与能量收集解决这个问题，传输调度 切换发射器进行了研究。在广播通信系统中包括两个发射器和两个用户。该 发射器获取能量和独立工作交替进行。传输调度问题转化为 最小化传输的完成时间，在能量的因果关系的约束，数据传输的限制，而 发射器的开关约束。发射器的开关被证明发射机不应该停止传输解决 之前切换到其他发射器和切换阈值应当是零。然后，一个最佳的发送策略是 基于对速度区域和发射器的开关机制，早期的作品提出。建议的最佳传输 政策可以达到更大的速度比区域若干种次优的传输策略。( To minimise transmission completion time in energy-harvesting rechargeable communication systems, various transmission scheduling schemes have been proposed. However, they did not consider the issue where a transmitter may fail before completing the transmission. To resolve this issue, transmission scheduling for broadcasting with energy-harvesting switching transmitters is studied. The broadcasting communication system consists of two transmitters and two users. The transmitters harvest energy independently and work alternately. The transmission scheduling problem is formulated as minimising the transmission completion time, under the energy causality constraint, the data transmission constraint, and the transmitter switching constraint. Transmitter switching is addressed by proving that a transmitter should not stop transmission before switching to the other transmitter and the switching threshold should be zero. Then, an optimal transmission policy is proposed based on earl)

ESIA System Architecture Second Edition

Power system stability and control

说明：  关于从摄像头实时读取图片的源码，并可以捕捉图片帧(Read about real-time images from the camera source, and can capture the picture frame)

MATLAB扩展编程。详细介绍了在MATLAB平台中的算法与源码(MATLAB extension programming. Details of the algorithm in MATLAB platform with source)

本文建立了独立悬架汽车整车七自由度动力学模型，推导了振动微分方程，运用数值仿真的手段研究了汽车悬架阻尼系数、刚度等设计参数对汽车振动特性的影响规律。结果表明，在共振区域附近，相对较大的刚度，会导致汽车的舒适性下降，但在共振区以外的高频区，刚度对汽车振动幅值的影响并不大；后桥悬挂阻尼对汽车振动幅值的影响较前桥强烈，适当增大后桥悬挂的阻尼有利于振动幅值的降低(This paper established an independent suspension vehicle dynamic model of seven degree of freedom, the vibration differential equation is derived, using the numerical simulation method of vehicle suspension damping coefficient, influence of design parameters on vehicle vibration characteristics of stiffness. The results show that in the resonance region, a relatively large stiffness, will lead to the comfort of the car down, but in the resonance region outside the high frequency region, the effect of stiffness of the vehicle vibration amplitude is small; the effect of damping on automobile suspension vibration amplitude is strongly increasing the rear axle axle, suspension damping to reduce the vibration amplitude)

基于半导体激光器的matlab程序产生混沌(chaos )

chirp信号示例的matlab程序以了解chrip信号基本特性(chirp signal example matlab program to understand the basic characteristics of the signal chrip)