cyclic_cross_correlation

Matlab routine for soft and hard decision viterbi decoding of convolutional codes

覆盖了全书的信号与线性系统、随机过程、模拟调制、模拟数字转换、基带数字传输、带限信道的数字传输、载波调制的数字传输、信道容量和编码、扩频通信系统以及数字调制方法的SIMULINK仿真的 源代码(Book covers the signal and linear systems, stochastic processes, analog modulation, analog-to-digital conversion, base-band digital transmission, band-limited digital transmission channel, the digital transmission carrier modulation, channel capacity and coding, spread spectrum communication systems, and digital modulation SIMULINK simulation method source code)

汽车悬架仿真建模，比较好，适合初学者学习(Simulation modeling of vehicle suspension, the better for beginners to learn)

动态演示不同参数下的lorenz混沌吸引子(Dynamic playing the different parameter of the lorenz chaos attractor)

系统鄙视程序，包括增广最小二乘法、递推最小二乘法等(System contempt procedures, including augmented least squares method, recursive least squares method, etc.)

dct与小波压缩，适用于毕业设计和论文呢(dct and wavelet compression)

pixel based image fusion

说明：  地球物理中的一种方法--MT，基于matlab,利用有限差分方法(the method for MT,which is based on the matlab and infinite difference method)

考虑L的三个不同值：L＝256（3个数据段），L＝128(7个数据段)和L=64（15个数据段）。各自的谱估计图如上图所示。可以明显的看到，加窗明显的减小了频谱上的假谱峰，但也更加进一步平滑了谱峰。所以，对于L＝64的情况，在ω＝0.8π的谱线可以很确定的辨认，但是那两个靠近的谱峰不容易区分。对于L＝128的情况，这种情况提供了在分离和检测间最好的均衡。当然，对于在L＝256时的情况，效果是更好的，能够从谱估计图上明显的分辨出三条谱线的存在以及它们幅度关系的强弱。 除了Welch法外，还可以采用对多个周期图求平均的功率谱估计方法的其他方法如Bartlett法等等，在功率谱估计上也能取得较好的结果。(consider three different values : L = 256 (3 data), L = 128 (7 data) and L = 64 (15 data). Their spectral estimation map as shown in Fig. It is clear to see that increase significantly decreasing window of the spectrum of false peaks, but much more to further smooth the peaks. Therefore, L = 64, in the case = 0.8 spectrum can determine the identification, but that the two peaks around is not easy to distinguish. L = 128 for the situation, which provided the separation and detection among the best balanced. Of course, L = 256 in the case, the effect is better, from the spectral estimation map clearly distinguish between the three lines of the existence and their relationship to the rate of strength. In addition to Welch law, but also can be used to map multiple cycle for the average power)

本程序是对V-BLAST系统及其检测算法的仿真，可采用BPSK,QPSK,16QAM,64QAM调制。检测算法为ML，MMSE,ZF,以及采用迫零的连续干扰消除检测算法。(V-blast ml mmse zf)