pm

pls算法工具箱。偏最小二乘回归≈多元线性回归分析＋典型相关分析＋主成分分析 (pls algorithm toolbox. Partial least-squares regression ≈ multiple linear regression analysis, canonical correlation analysis++ Principal component analysis)

Create video by using computer vision toolbox in matlab and write it to the disk. this is using webcam.

基于PID算法的飞思卡尔智能车路径跟踪matlab仿真(PID algorithm based on the Freescale smart car path tracking matlab simulation)

多天线系统中球形检测算法matlab源程序，包括仿真结果(Multi-antenna system sphere detection algorithm matlab source, including the simulation results)

program for sampling and reconstruction

麻省理工大学-信号与系统--MATLAB导论 基本使用手册(MIT-Signals and Systems--MATLAB USER GUIDE)

LATEX and BEAMER for beginners.

自己编的matlab程序，应用FDTD数值算法仿真了3D情况下偶极子天线辐射方向图，希望对大家有所帮助！(it can be used to simulated the dipole antenna.by using the matlab language,the radiation pattern is simulated by using FDTD algrthom!)

这个程序是基于matlab的计算工件粗糙度的轮廓算术平均偏差Ra的值。里面有例程，还有详细的代码注释，希望对各位有所帮助，代码段还有不完善的地方，运行时间过长，会报错，但是逻辑是没有问题的，日后再改进大家可以基于此来书写新的程序，算是抛砖引玉吧(This procedure is based on the calculation of the value of matlab workpiece contour arithmetic average roughness Ra of deviation. There are routines, as well as detailed code comments, you would like to help, there are imperfections in the code segment, at a later improvement, but logic should be no problem, we can be written based on this new program, regarded puts it)

根据有无固定基础设施，无线局域网又可分为BSS (Basic Service Set)和IBSS (Independent Basic Service Set)。我们要研究的ad hoc网络属于后者。假设在一个ad hoc网络中，移动节点的发射功率PTx总是恒定的。要发送数据的移动节点总是先监听信道，测量接收到的信号功率X，其中X= I + N, I为接收到的干扰，N是噪声。移动节点只有在X＜INThre时，才可以发射。式中，INThre为背景噪声门限。 在仿真中，我们规定每个移动节点的发射功率是常数，PTx = 1W；接收节点接收机的灵敏度Smin = -80 dBm；信号质量 min = 2 dB；系统的背景噪声门限INThre = 1.2e-10。 (According to the availability of fixed infrastructure, wireless local area network can be divided into BSS (Basic Service Set) and IBSS (Independent Basic Service Set). We have to study the ad hoc network belong to the latter. Assuming in an ad hoc network, mobile node s transmission power is always constant PTX. To send data to the mobile node always monitor channel, measuring the received signal power X, which X = I+ N, I was received interference, N is the noise. Mobile node only when X <INThre when it is fired. Where, INThre threshold for background noise. In the simulation, we require that each mobile node s transmission power is constant, PTx = 1W receiver node receiver sensitivity Smin =-80 dBm signal quality )