登录
首页 » matlab » bit_interleaving

bit_interleaving

于 2008-08-31 发布 文件大小:1KB
0 269
下载积分: 1 下载次数: 0

代码说明:

说明:  UWB_信道交织,包括符号交织,音频交织和循环移位(Channel UWB_ intertwined, including symbols intertwined, audio intertwined and cyclic shift)

下载说明:请别用迅雷下载,失败请重下,重下不扣分!

发表评论

0 个回复

  • GraphViz
    grape visualizer programme
    2012-07-25 01:07:26下载
    积分:1
  • MATLABduomubiaoyouhua
    matlab多目标优化问题实现,可以参考一下啊(matlab multi-objective optimization, you can refer to ah)
    2010-01-17 17:19:07下载
    积分:1
  • 16-QAM-fadingchannels
    series of codes for simulation of 16-QAM BER over fading and AWGN channels
    2010-02-07 22:26:55下载
    积分:1
  • lorentz
    Simulates Lorenz Map
    2014-09-14 11:02:26下载
    积分:1
  • eemdd
    经验模式分解改进代码,基于经验模式分解的一种改进 经验模式分解 matlab(Empirical Mode Decomposition improve code)
    2013-09-22 09:56:17下载
    积分:1
  • MATLAB-based-voice-signal-analysis
    MATLAB-based voice signal analysis and processing curriculum design
    2013-04-10 10:36:07下载
    积分:1
  • UEFA
    实现对欧洲足球冠军联赛16强抽签的仿真,球队采用本赛季产生的16支球队。(Implementation of European football simulation, 16 of the champions league draw teams using the 16 teams this season.)
    2013-12-12 22:40:05下载
    积分:1
  • OFDM-basedWirelessBroadBandSystemSimulator
    基于OFDM的无线宽带系统仿真It contains mainly two parts, i.e. link-level simulator and system-level simulator. Link-level simulator focus on a single-cell single-user scenario, where signal is transmitted from tx, and estimated at rx. Comparing the difference in tx/rx signal, the error rate can be found out. The output of the link-level simulator is the BLER/BER vs. SNR mapping table, that can be used for the system-level simulation. System-level simulator focus on a multi-cell multi-user scenario. For the sake of simplicity, it takes the mapping table aquired in the link-level simulation, measure the actural SNR, and finds the corresponding error rate.(OFDM-based wireless broadband system simulation It contains mainly two parts, ie link-level simulator and system-level simulator.Link-level simulator focus on a single-cell single-user scenario, where signal is transmitted from tx, and estimated at rx . Comparing the difference in tx/rx signal, the error rate can be found out. The output of the link-level simulator is the BLER/BER vs. SNR mapping table, that can be used for the system-level simulation.System- level simulator focus on a multi-cell multi-user scenario. For the sake of simplicity, it takes the mapping table aquired in the link-level simulation, measure the actural SNR, and finds the corresponding error rate.)
    2008-01-05 00:08:29下载
    积分:1
  • BOCostFunction
    说明:  解决线性assignment的算法,c++实现,并且提供matlab接口,编译后可以用matlab调用(Solve the linear assignment algorithm, c++ Realize, and to provide matlab interface, the compiler can be used after the call matlab)
    2008-09-09 13:56:31下载
    积分:1
  • SVPWM2
    三相全控桥SVPWM matlab(simulink)的仿真电路(Three-phase full-controlled bridge SVPWM matlab (simulink) circuit simulation)
    2011-10-25 16:04:51下载
    积分:1
  • 696516资源总数
  • 106914会员总数
  • 0今日下载