-
usingmatlab
using matlab litlle introduction and instruction
- 2009-05-09 00:21:12下载
- 积分:1
-
beetleex
The classical beetle data is analysed using logistic regression and MCMC.
- 2010-12-08 17:03:35下载
- 积分:1
-
moPSO
基于多目标的PSO用于解决背包问题的程序,运行上比较花时间,请耐心等待。(Procedures used to solve the knapsack problem based on multi-objective PSO run more to spend time, please be patient.)
- 2012-05-19 10:29:13下载
- 积分:1
-
8psk
8位相移键控误码率分析的MATLAB程序(8 phase shift keying bit error rate analysis of the MATLAB program)
- 2010-11-27 22:28:22下载
- 积分:1
-
Fuzzy-control
智能控制理论关于Fuzzy control的一个实例,包括任务书和matlab源代码(Intelligent Control Theory on the Fuzzy control of an instance, including the mission statement and the source code matlab)
- 2011-05-10 16:38:32下载
- 积分:1
-
find_peak
从曲线中检测到其峰值:先利用二次求导得到所有凸点,设置门限,去除过低的凸点,然后利用滑动窗的方法,在凸点中求得满足峰值要求的点(Detected from the curve to its peak: the first use of the second derivative method to get all the bumps, set the threshold too low to remove the bumps, and then use a sliding window, obtained in a bump to meet peak requirements of point)
- 2014-02-24 16:32:16下载
- 积分:1
-
calcAngularDerivative
This function calculates the radial derivative of an input image.
Input parameters:
inputImage - the image to calculate the derivative from
radialFilterLength - the length of the filter to use, total length
will be 2*radialFilterLength+1
centerX and centerY - the point that is considered the center of the
image, for the calculation
minRadius and maxRadius - the minimum and maximum radius to calculate
the angular derivative for.
radialApproach - set to 1 to use a radius and angle search method, or 0
for a per-pixel approach
- 2010-02-09 07:55:45下载
- 积分:1
-
V-BLAST-detection-algorithm
本程序是对V-BLAST系统及其检测算法的仿真,可采用BPSK,QPSK,16QAM,64QAM调制。检测算法为ML,MMSE,ZF,以及采用迫零的连续干扰消除检测算法。(This procedure is the V-BLAST detection algorithm and the simulation system can be used BPSK, QPSK, 16QAM, 64QAM modulation. Detection algorithm for the ML, MMSE, ZF, and the use of zero-forcing successive interference cancellation detection algorithm.)
- 2011-05-22 14:54:25下载
- 积分:1
-
2.5.3
利用firpmord和firpm函数设计双带通滤波器,其指标为,第一带通指标:f =4kHz,f =5 kHz ,f =3.6 kHz ,f =5.4 kHz
第二带通指标:f =6kHz,f =7 kHz ,f =5.6 kHz ,f =7.4 kHz
通带衰耗A <3dB,阻带衰耗A >40dB,抽样频率f =20kHz。(Double belt pass filter using firpmord and firpm function design, for its indicators, through the first area index: f = 4 kHz, f = 5 kHz, f = 3.6 kHz, f = 5.4 kHz
The second bandpass indicators: f = 6 kHz, f = 7 kHz, f = 5.6 kHz, f = 7.4 kHz
Pass band attenuation A < 3 db, stop-band attenuation A > 40 db, f = 20 KHZ sampling frequency.)
- 2014-11-28 16:08:46下载
- 积分:1
-
2-DOF-Quarter-Car-Model
二自由度四分之一车模型,matlab/simulink(Two degrees of freedom quarter car model, matlab/simulink)
- 2013-06-09 00:32:29下载
- 积分:1