登录
首页 » matlab » apfft

apfft

于 2010-03-15 发布 文件大小:1KB
0 307
下载积分: 1 下载次数: 355

代码说明:

  Matlab实现的全相位频谱分析,可以自行设定点数和输入序列。结果包括频谱图和与普通fft的对比(Matlab to achieve all-phase spectral analysis, can draw up a point and input sequence. The results include the spectral figure and the comparison with ordinary fft)

文件列表:

apfft.m

下载说明:请别用迅雷下载,失败请重下,重下不扣分!

发表评论

0 个回复

  • bluetuch-test-Program
    bluetuch 检测程序,bluetuch 检测程序(bluetuch test source code .bluetuch test source code )
    2009-12-22 15:25:46下载
    积分:1
  • Fig_blind_signals_seperation
    用于盲信号分离的白化预处理程序,使用的是自然梯度算法。(A matlab program used for pre-whitening in blind signals seperation.)
    2010-01-02 22:05:28下载
    积分:1
  • klm
    利用Kalman滤波器通过测量信号估计x(n)的波形(Using Kalman filter estimates by measuring the signal x (n) waveform)
    2011-01-04 22:42:08下载
    积分:1
  • 1
    基于matlab简单图像处理系统中对图片进行增强对比度的处理(Based on a simple matlab image processing system to enhance the contrast of the picture processing)
    2014-01-19 22:06:36下载
    积分:1
  • Elfouhaily
    绘制Elfouhaily海浪谱,对于研究GNSS-R反演海面风速的很有帮助(Drawing the Elfouhaily wave spectrum is very helpful in studying GNSS-R inversion of sea surface wind speed.)
    2021-04-13 11:48:56下载
    积分:1
  • ta_
    说明:  时间混叠信号matlab程序,是利用时间混叠信号进行循环谱估计的前提。该程序用于证明时间混叠后信号为周期信号。(Time Aliasing)
    2010-04-12 11:22:41下载
    积分:1
  • identificationwiththeSimulationReport
    基于MATLAB的递推最小二乘法辨识与仿真报告(MATLAB-based parameter identification with the Simulation Report)
    2010-05-19 09:50:40下载
    积分:1
  • PID
    使用matlab设计PID控制器消除系统静态速度误差的方法,主要使用等幅振荡法,并通过WORD给出了传递函数。(PID controller design using matlab static speed error elimination systems approach, the main use of the oscillation amplitude France, and through the WORD gives the transfer function.)
    2013-10-29 20:54:26下载
    积分:1
  • AIC
    赤池准则 可以实现噪声检测 P波震相捡拾 S波震相捡拾等地震学基本操作等(Akaike criterion can achieve noise detection P-wave seismic phase picking S phases pick up basic operations such as seismology, etc.)
    2021-03-15 08:49:22下载
    积分:1
  • handover_topsis_fuzzy
    The code is used to simulate the handover mechanism between WiMAX and 3G networks using topsis method with fuzzy logic. At the end of the simulation results are plotted in the form of graphics.
    2014-10-02 17:59:01下载
    积分:1
  • 696516资源总数
  • 106914会员总数
  • 0今日下载